ISSN：1003-8620

CN：42-1243/TF

主管：中信泰富特钢集团股份有限公司

主办：大冶特殊钢有限公司

特殊钢 ›› 2017, Vol. 38 ›› Issue (2): 60-63.

• 组织和性能 • 上一篇    下一篇

220t BOF-LF-VD-板坯CC 流程管线钢精炼和连铸过程钢液洁净度的演变

杨光维1，王新华2   

  1. 1. 宝山钢铁股份有限公司研究院，上海 201900 ；
    2. 北京科技大学冶金与生态工程学院，北京 100083；
  • 收稿日期:2016-10-29 出版日期:2017-04-01 发布日期:2022-07-23
  • 作者简介:杨光维(1986-),男，博士生(2015年北京科技大学)，工程师，2009年北京科技大学(本科)毕业，转炉炼钢，二次精炼，非金属夹杂物研究。

Evolution of Liquid Cleanliness of Pipeline Steel in Refining and Casting Process of 220t BOF-LF-VD-Slab CC Flowsheet

Yang Guangwei1 ,  Wang Xinhua2   

  1. 1. Research Institute, Baoshan Iron and Steel Co Ltd, Shanghai 201900；
    2. School of Metallurgical and Ecological Engineering, University of Science and Technology, Beijing 100083;
  • Received:2016-10-29 Published:2017-04-01 Online:2022-07-23

PDF

304

摘要： 试验X52管线钢（/%:0.070~0.079C，0.22Si，1.29~1.32Mn，0.008~0.009P，0.002S，0.028A1，0.0016~0.0017T[O]，0.0053~0.0065N）的冶金流程为铁水预处理-220t BOF-LF-VD-230 mm板坯连铸。主要工艺为BOF出钢加铝粒，LF精炼渣主要组成为（/%）:54.41~58.54CaO，7.66~8.42SiO2，22.57~24.69Al2O3，4.15~4.58MgO，0.78~2.89FeO；VD后喂钙线处理。利用电子束和X-射线技术的ASPEX自动扫描电镜研究了该钢冶炼过程夹杂物的变化。结果表明，LF进站时钢中夹杂物为簇群状或颗粒状Al2O3，LF终点Al2O3转变为球状CaO-MgO-Al2O3系夹杂物，钙处理后转变为球状CaO-Al2O3-CaS系。VD真空处理过程夹杂物数量从30~35个/mm2降至7~15个/mm2、T[O]和[N]大幅降低至12×10-6~13×10-6和41×10-6~48×10-6。软吹搅拌到中间包,钢中夹杂物数量剧增至33个/mm2。夹杂物平均尺寸在VD破空后达到最大,为2.6~3.6μm,中间包则减小到1.9~2.1μm。喂线及软吹搅拌过程钢中T[O]和[N]都有增加,说明发生了二次氧化。LF精炼、VD及钙处理后钢中S含量降至16×10-6。中间包覆盖剂中（SiO2）和（FeO+MnO）太高会导致中间包钢水回硫。

关键词: X52 管线钢, Al2O3, CaO-MgO-Al2O3, CaO-Al2O3-CaS, ASPEX, 洁净度

Abstract: The metallurgical flow sheet of tested pipeline steel X52 (/% : 0.070~0.0790, 0.22Si, 1.29~1.32Mn, 0.008~0.009P, 0.002S, 0.028Al, 0.0016~0.0017T[O], 0.0053〜0.0065N) is hot-metal pretreatment- 220t BOF-LF-VD-230 mm slab CC. The main steelmaking processes are adding aluminium shot in tapping of BOF； main ingredient of LF refining slag- (/%) : 54.41~58.54CaO, 7.66~8.42SiO2, 22.57~24.69A12O3, 4.15〜4.58MgO, 0.78~2.89FeO ； and feeding calcium wire treatment after VD. The evolution of inclusions in steel during steelmaking process is studied by auto scanning electron microscope with ASPEX ( Application Specific Products employing Electron Beam and X-ray technology). Results show that before LF refining the inclusions in liquid are AI2O3 cluster and granule, after LF refining the Al2O3 is modified to globular CaO-MgO-Al2O3, inclusion, then modified to globular CaO-Al2O3-CaS inclusion after calcium treatment; by VD treatment the number of inclusions in liquid decreases from 30〜35/mm2 to 7~15/ mm2 and the T[O] and [N] markedly decrease to 12 x 10-6~13 x 10-6 and 41 x 10-6~48 X 10-6. from end soft stirring to tundish the number of inclusions in liquid dramatically increases to 33/mm2 ； at end VD the average size of inclusions is up to maximum i. e. 2.6~3.6 μm, but in tundish that decreases to 1.9~2.1 μm: during feeding wire and soft blowing process the T[O] and [N] increase to some extent, it shows that the secondary oxidation of liquid occurs； with LF refining, VD and calcium treatment the S content in steel decreases lo 16 x 10 ; and the high (SiO2) and ( FeO + MnO) content in tundish shielding flux lead to resulfurization of liquid in tundish.

Key words: X52 Pipeline Steel, Al2O3, CaO-MgO- Al2O3, CaO- Al2O3-CaS, ASPEX, Cleanliness

鄂ICP备2022000839号
网站版权 © 2021 《特殊钢》编辑部 技术支持：北京玛格泰克科技发展有限公司