压力容器用14CrlMoR钢奥氏体连续冷却转变曲线

特殊钢 ›› 2016, Vol. 37 ›› Issue (4): 41-43.

压力容器用14CrlMoR钢奥氏体连续冷却转变曲线

赵燕青¹，吴艳阳²，刘艳丽¹，陈振业¹，张鹏¹，刘宏强¹

1河北钢铁技术研究总院,石家庄050000；
2河北钢铁集团舞阳钢铁有限责任公司,平顶山462500

收稿日期:2016-02-18 出版日期:2016-08-01 发布日期:2022-08-03
作者简介:赵燕青(1984-),男，硕士(2011年北京科技大学),工程师，2008年河北工业大学(本科)毕业,轧钢工艺及金属热处理研究。

Continuous Cooling Transformation Curves of Austenite of Steel 14CrlMoR for Pressure Vessel

Zhao Yanqing¹ , Wu Yanyang², Liu Yanli¹ , Chen Zhenye¹, Zhang Peng¹ Liu Hongqiang¹

1 Hebei Iron and Steel Technology Research General Institute, Shijiazhuang 0500CX；
2 Wuyang Iron and Steel Co Ltd, Hebei Iron and Steel Group, Pingdingshan 462500

Received:2016-02-18 Published:2016-08-01 Online:2022-08-03

摘要/Abstract

摘要： 利用膨胀仪测定了14CrlMoR钢（/%:0.01C,0.66Si,0.80Mn,0.006P,0.003S,1.72Cr,0.31Mo,0.01Nb）的临界点及连续冷却转变曲线并研究了冷却速度对试验钢的组织及显微硬度的影响。结果表明,当冷却速度为0.1~1℃/s时,试验钢的转变组织为铁素体和珠光体;2~5℃/s时,试验钢得到铁素体、珠光体以及少量粒状贝氏体的混合组织;10℃/s时,试验钢组织为铁素体和粒状贝氏体;15~20℃/s时为板条贝氏体组织;25~50℃/s时,该钢得到板条贝氏体和马氏体的混合组织。

Abstract: The critical points and continuous cooling transformation curves of steel 14CrlMoR (/% ：0. 01C, 0. 66Si,0. 80Mn, 0. 006P, 0. 003S, 1.72Cr, 0.31 Mo, 0. 01 Nb) are measured by dilatometer, and the effect of cooling rate on structure and microhardness of test steel is studied. Results show that with cooling rate 0. 1 ~ 1℃ /s the transformed structure of tested steel is ferrite and pearlite； with 2 ~5℃ /s the tested steel obtains mixed structure of ferrite, pearlite and minor granular bainite； with 10℃/s the structure of test steel is ferrite and granular bainite； with 15 ~20℃/s the structure is lath bainite ；and with 25 ~5℃/s the steel gets the mixed structure of lath bainite and martensite.

赵燕青, 吴艳阳, 刘艳丽, I陈振业, 张鹏, 刘宏强. 压力容器用14CrlMoR钢奥氏体连续冷却转变曲线[J]. 特殊钢, 2016, 37(4): 41-43.

Zhao Yanqing , Wu Yanyang, Liu Yanli , Chen Zhenye, Zhang Peng Liu Hongqiang. Continuous Cooling Transformation Curves of Austenite of Steel 14CrlMoR for Pressure Vessel[J]. Special Steel, 2016, 37(4): 41-43.