ISSN:1003-8620

CN:42-1243/TF

主管:中信泰富特钢集团股份有限公司

主办:大冶特殊钢有限公司

特殊钢 ›› 2010, Vol. 31 ›› Issue (4): 40-42.

• 工艺技术 • 上一篇    下一篇

120 t转炉流程管线钢X70的生产实践

秦军   

  1. 宝钢集团新疆八钢股份公司第二炼钢厂,乌鲁木齐830022
  • 收稿日期:2010-03-05 出版日期:2010-08-01 发布日期:2022-11-20
  • 作者简介:秦军(1974-),男,高级工程师,1995年重庆大学毕业,炼钢和连铸工艺研究。

Practice of X70 Pipeline Steel Production by 120 t Converter Flow Sheet

Qin Jun   

  1. No2 Steelmaking Plant, Xinjiang Bagang Co Ltd, Wulumuqi 830022
  • Received:2010-03-05 Published:2010-08-01 Online:2022-11-20

摘要: X70管线钢(%:0.02~0.05C、0.145~0.25Si、≤0.015P、≤0.002S、1.70~1.80Mn、0.085~0.15Nb、0.2~0.3Ni、0.015~0.040Al、0.01~0.03Ti)用铁水预处理-120 t转炉-RH-LF-(200~250)mm×(900~1 800)mm连铸工艺冶炼。通过金属锰替代低碳锰铁和部分硅锰合金,减少RH处理后钢水增碳,控制LF精炼时钢水增C量≤0.01%,预处理铁水[S]≤0.002%,LF精炼渣碱度控制在1.5左右,使LF初始[C]为0.03%,初始[S]为0.001 5%,终点[C]为0.04%,终点[S]为0.000 8%,满足了使用要求。

Abstract: The X70 pipeline steel (% : 0. 02 - 0. 05C, 0. 145 〜0. 25Si, ≤0. 015P, Wt). 002S, 1. 70 ~ 1. 80Mn, 0. 085 ~ 0. 15Nb, 0. 2 - 0. 3Ni, 0. 015 ~ 0. 040Al, 0. 01 ~ 0. 03Ti) is produced by hot metal pretreatment - 120 t converter - RH - LF - (200 ~ 250) mm x (900 ~ 1 800) mm slab concasting process. With metal manganese to replace low- carbon ferro-manganese and partial silico-manganese to decrease carbon pickup amount in liquid after RH treatment, controlling LF liquid carbon pickup amount ≤0. 01 %, controlling pretreated hot metal [ S] ≤0. 002% and basicity of LF refining slag being about 1.5, the LF initial [ C] and [ S] are respectively 0. 03% and 0. 001 5%, and the LF end [ C] and [S] are respectively 0. 04% and 0. 000 8%, to meet the requirement of service.