Through the laboratory water mold experiment

the best way to add desulfurizer is spray suction type，during production process by measures like adjusting the Angle of the desulphurization spray gun to be close to 90°

the relative height of the spray gun to be 500 mm

the injection point of the desulphurization agent to be within 1/2 radius

the particle size of the desulphurization agent to be no more than 2 mm

the injection speed to be 130-150 kg/min

the powder/gas ratio to be 75 kg/Nm

3

and the high-speed stirring time to be 4-6 minutes

etc

it solves the problems of low desulfurization efficiency caused by pipe clogging

splashing and unstable desulfurization yield in the actual production process

and gives full play to the advantages of desulfurization by spraying. Compared with the batch adding (gravity)method

the saving desulfurizer can reach about 25%.