1.浙江久立特材科技股份有限公司,湖州 313028
2.浙江久立金属材料研究院有限公司,湖州 313028
3.中国钢研科技集团有限公司,北京 100000
王哨兵(1989—),男,硕士,工程师; E-mail:shaobingW@126.com
收稿:2023-11-06,
纸质出版:2024-09-30
移动端阅览
王哨兵,孙文强,王曼等.Nb对GH4169合金管材组织性能的影响[J].特殊钢,2024,45(05):34-39.
Wang Shaobing,SunWenqiang ,Wang Man,et al.The Effect of Nb on Microstructure and Properties of GH4169 Alloy Pipe[J].Special Steel,2024,45(05):34-39.
王哨兵,孙文强,王曼等.Nb对GH4169合金管材组织性能的影响[J].特殊钢,2024,45(05):34-39. DOI: 10.20057/j.1003-8620.2023-00224.
Wang Shaobing,SunWenqiang ,Wang Man,et al.The Effect of Nb on Microstructure and Properties of GH4169 Alloy Pipe[J].Special Steel,2024,45(05):34-39. DOI: 10.20057/j.1003-8620.2023-00224.
采用真空感应、电渣重熔、真空自耗、均匀化热处理、锻造、热挤压、冷轧、热处理等工艺得到Nb含量分别为4.90%和5.30%的两种GH4169合金管,在其他成分基本保持一致的情况下,研究了Nb含量对GH4169合金管材组织性能的影响。结果表明,在相同的热处理工艺下,随着Nb含量的增加,Nb含量越高,晶粒尺寸越细小;200 ℃和室温抗拉强度、屈服强度都随着Nb含量的增加而增加;且在GH4169合金管材中的析出相含量也增加。GH4169合金管在不同的固溶热处理和相同的时效热处理工艺下,得到GH4169合金管材的晶粒度尺寸在4.0~7.0级,晶粒尺寸越小,管材的抗拉强度和屈服强度越高;在相同的晶粒度下,Nb含量越高,管材的抗拉强度、屈服强度都随着Nb含量的增加而增加。
With the manufacturing process by vacuum induction, electroslag remelting, vacuum self consumption, homogenization heat treatment, forging, hot extrusion, cold rolling, and heat treatment. we can get two types of GH4169 alloy pipes with Nb content of 4.90% and 5.30% respectively. The effect of Nb content on the microstructure and properties of GH4169 alloy pipes was studied while other components remained basically the same. The results show that under the same heat treatment process, with the increase of Nb element content, the Nb content becomes higher and the grain size becomes smaller; At 200 ℃ and room temperature with the tensile strength and yield strength both increase with the increasing of Nb content, And the content of precipitates in GH4169 alloy pipes also increases. Under different solid solution heat treatments and the same aging heat treatment process, the grain size of GH4169 alloy pipes is in the range of 4.0-7.0. The smaller the grain size, the higher the tensile strength and yield strength of the pipes; At the same grain size, the higher the Nb content, the higher the tensile strength and yield strength of the pipe.
师昌绪 , 仲增墉 . 中国高温合金40年 [J]. 金属学报 , 1997 , 33 ( 1 ): 1 - 8 .
KurtP . Rohrbach .高温合金的发展与选择[J]. 宇航材料与工艺 , 2005 ,35 ( l ) :61- 62 .
杜金辉 , 邓群 , 董建新 . 我国GH4169合金的发展与应用 [A].见原:师昌绪,仲增墉主编. 中国高温合金五十年[C] . 第1 版 . 北京 : 北京工业出版社 , 2006 : 1 .
徐 强 , 张幸红 , 韩杰才 , 等 . 先进高温材料的研究现状和展望 [J]. 固体火箭技术 , 2002 , 25 ( 3 ): 51 - 55 .
丁天胜 , 张显程 , 涂善东 , 等 . 热处理对GH4169合金组织及650 ℃下低周疲劳性能的影响 [J]. 材料热处理学报 , 2016 , 37 ( 4 ): 69 - 75 .
孔永华 , 李 龙 , 陈国胜 , 等 . 不同热处理工艺对GH4169合金组织及性能的影响 [J]. 稀有金属材料与工程 , 2010 , 39 ( S1 ): 472 - 475 .
魏先平 , 郑文杰 , 宋志刚 , 等 . 热处理对Inconel718合金组织及力学性能的影响 [J]. 材料热处理学报 , 2012 , 33 ( 8 ): 53 - 58 .
白亚冠 , 李红梅 , 韩秀栋 , 等 . GH4169合金δ相析出与溶解行为研究 [J]. 特殊钢 , 2021 , 42 ( 5 ): 21 - 25 .
韦家虎 , 董建新 , 喻 健 , 等 . δ相对GH4169合金热变形行为的影响 [J]. 航空材料学报 , 2012 , 32 ( 6 ): 72 - 77 .
张海燕 , 张士宏 , 程 明 , 等 . δ相对GH4169合金热变形后热处理中晶粒长大的影响 [J]. 材料热处理学报 , 2017 , 38 ( 3 ): 70 - 75 .
刘 芳 , 孙文儒 , 杨树林 , 等 . Al含量对GH4169镍基合金组织及其稳定性的影响 [J]. 金属学报 , 2008 , 44 ( 7 ): 791 - 798 .
蔡大勇 . GH169及GH696高温合金热加工工艺基础研究 [D]. 秦皇岛 : 燕山大学 , 2003 .
孔永华 , 刘瑞毅 , 陈国胜 , 等 . 不同固溶处理对GH4169合金常温拉伸性能的影响 [J]. 稀有金属材料与工程 , 2012 , 41 ( S2 ): 616 - 620 .
朱丽娜 . GH4169G合金显微组织和力学性能研究 [D]. 沈阳 : 沈阳理工大学 , 2011 .
0
浏览量
1
下载量
0
CSCD
0
CNKI被引量
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621