1.燕山大学机械工程学院,秦皇岛 066004
2.北方工业大学机械与材料工程学院,北京 100114
高小勇(1984—),男,博士,讲师;E-mail:gaoxiaoyong@ysu.edu.cn
收稿:2024-03-22,
纸质出版:2024-07-30
移动端阅览
高小勇,张立峰.三七渣电渣重熔对M50高温轴承钢中夹杂物的影响[J].特殊钢,2024,45(04):89-93.
Gao Xiaoyong,Zhang Lifeng.Effect of Electroslag Remelting Using 37 Slag on Inclusions in M50 High-temperature Bearing Steel[J].Special Steel,2024,45(04):89-93.
高小勇,张立峰.三七渣电渣重熔对M50高温轴承钢中夹杂物的影响[J].特殊钢,2024,45(04):89-93. DOI: 10.20057/j.1003-8620.2024-00068.
Gao Xiaoyong,Zhang Lifeng.Effect of Electroslag Remelting Using 37 Slag on Inclusions in M50 High-temperature Bearing Steel[J].Special Steel,2024,45(04):89-93. DOI: 10.20057/j.1003-8620.2024-00068.
非金属夹杂物是影响高温轴承钢疲劳性能的重要因素。为了提高M50高温轴承钢的夹杂物控制水平,分析了三七渣电渣重熔精炼技术对夹杂物的影响。采用场发射扫描电子显微镜和能谱仪对夹杂物进行了表征,采用X射线荧光光谱仪分析了电渣重熔前后渣料成分的变化。在自耗电极中,夹杂物为尺寸较小的Al
2
O
3
-SiO
2
,其中,
w
[SiO
2
]较高(平均值为29.3%),不存在聚集状夹杂物。经过电渣重熔,夹杂物转变为Al
2
O
3
,而且存在大尺寸的簇状夹杂物;渣料中
w
[SiO
2
]从1.73%增加到3.42%,同时Al
2
O
3
含量发生降低;钢中
w
[Al]从<0.000 5%显著增加到0.020 7%,
w
[Si]从0.356%降低至0.296%。基于渣-钢反应理论对电渣重熔过程的冶金反应进行了解释。钢液中的溶解Si和熔渣中的Al
2
O
3
在钢液和熔渣的界面发生反应,产物为溶解Al和SiO
2
。随后溶解Al扩散进入钢液并与夹杂物中SiO
2
发生反应,产物为溶解Si和Al
2
O
3
。最终使得钢中夹杂物转变为Al
2
O
3
。提出了控制三七渣电渣重熔M50轴承钢中夹杂物的方法。
Non-metallic inclusion is a important factor affecting the fatigue property of high-temperature bearing steel. The effect of electroslag remelting (ESR) using 37 slag on inclusions of M50 high-temperature bearing steel was investigated in order to improve the level of inclusion control. Inclusions were characterized by field emission scanning electron microscope equipped with energy dispersive spectrometer. The ingredients of slags before and after ESR was analyzed by X-ray fluorescence method. In the consumable electrode, inclusions were finer Al
2
O
3
-SiO
2
with high SiO
2
content (about 29.3% in average value). No inclusions clusters were observed.After ESR, inclusions changed to Al
2
O
3,
the clusters inclusions with large size were observed. The content of SiO
2
in the slag increased from 1.73% to 3.42%, and the Al
2
O
3
content decreased; The content of Al in the steel increased significantly from
<
0.000 5% to 0.020 7%, and the content of Si in the steel decreased from 0.356% to 0.296%. The metallurgical
reaction during ESR was explained based on slag-steel reaction theory. The dissolved Si in the steel reacted with Al
2
O
3
of the molten slag at the interface between molten steel and slag, and the products were dissolved Al and SiO
2
. Subsequently, dissolved Al diffused into the molten steel and reacted with SiO
2
of the inclusions, and the products were dissolved Si and Al
2
O
3
. In the end, inclusions in the steel were transformed into Al
2
O
3
.The methods to control inclusions of M50 bearing steel during ESR using 37 slag were proposed.
侯志远 , 刘威峰 , 徐 斌 , 等 . M50轴承钢热变形过程中孔洞形成及演化机制 [J]. 金属学报 , 2024 , 60 ( 1 ): 57 - 68 .
徐 亮 , 李 涛 , 马永强 , 等 . 退火工艺对高温轴承钢M50钢材晶粒度的影响 [J]. 特殊钢 , 2022 , 43 ( 6 ): 50 - 53 .
Rescalvo J A , Averbach B L . Fracture and fatigue in M-50 and 18-4-1 high speed steels [J]. Metallurgical Transactions A , 1979 , 10 ( 9 ): 1265 - 1271 .
邓朝辉 , 陈 云 , 巩桐兆 , 等 . 高纯稀土对M50钢液析碳化物的影响 [J]. 材料研究学报 , 2023 , 37 ( 12 ): 915 - 923 .
Bhadeshia H K D H . Steels for bearings [J]. Progress in Materials Science , 2012 , 57 ( 2 ): 268 - 435 .
Wei W T , Ke J Z , Liu Z , et al . Understanding the microstructural evolution and fretting wear behaviors of M50 bearing steel heat treated at different temperatures [J]. Journal of Materials Research and Technology , 2023 , 27 : 6661 - 6671 .
Wei P , Bai P P , Yue L , et al . Comparing friction behavior and mechanism of three generation bearing steel (GCr15, M50, CSS-42 L) paired silicon nitride under ester oil lubrication from room temperature to 350 °C [J]. Journal of Materials Research and Technology , 2024 , 30 ( 2 ): 1354 - 1367 .
Zeng Q F , Zheng C J , Wei X K . Study of the corrosion behaviors of M50 steel in brine-contaminated lubricating oil [J]. International Journal of Electrochemical Science , 2024 , 19 ( 6 ): 100572 .
崔 毅 , 张雲飞 , 俞 峰 , 等 . 高温轴承钢M50连续冷却转变曲线的测定与分析 [J]. 特殊钢 , 2022 , 43 ( 3 ): 85 - 90 .
Guan J , Liu D R , Cao Y F , et al . Macro and micro segregations and prediction of carbide equivalent size in vacuum arc remelting of M50 steel via simulations and experiments [J]. Metallurgical and Materials Transactions A , 2024 , 55 ( 4 ): 1081 - 1097 .
Butterfield F A III , McNelley T R . Porosity associated with insoluble carbides in VIM-VAR AISI M-50 steel and its probable effects on rolling contact fatigue [J]. Journal of Tribology , 1986 , 108 ( 3 ): 352 - 357 .
张云飞 , 崔毅 , 赵英利 , 等 . 热加工对GCr4Mo4V钢显微组织及疲劳性能的影响规律 [J]. 热加工工艺 , 2023 . DOI: 10.14158/j.cnki.1001-3814.20221972 http://dx.doi.org/10.14158/j.cnki.1001-3814.20221972 .
Yang L Q , Xue W H , Cao Y F , et al . Investigation on butterfly white etching area formation mechanism and crack source at different stages in M50 bearing steel [J]. Tribology International , 2024 , 193 : 109429 .
Liu C , Revilla R I , Zhang D W , et al . Role of Al 2 O 3 inclusions on the localized corrosion of Q460NH weathering steel in marine environment [J]. Corrosion Science , 2018 , 138 : 96 - 104 .
王冰杰 , 王宇 , 项淼苗 , 等 . 低频电渣重熔过程电流强度对电渣锭洁净度的影响 [J]. 特殊钢 , 2024 , 45 ( 4 ): 1 - 6 .
张家雯 , 李正邦 , 杨海森 , 等 . 无氟渣电渣重熔及铸锭的凝固组织 [J]. 钢铁研究学报 , 1990 , 2 ( 2 ): 1 - 8 .
赵俊学 , 李永波 , 张振强 , 等 . 电渣重熔过程ANF-6渣Al 2 O 3 选分结晶对渣皮成分和组织的影响 [J]. 特殊钢 , 2014 , 35 ( 6 ): 9 - 11 .
Wang Q , Wang L J , Zhai J , et al . Evolution of inclusions in Fe-13Cr treated by CaO-SiO 2 -Al 2 O 3 -based top slag [J]. Metallurgical and Materials Transactions B , 2017 , 48 ( 1 ): 564 - 572 .
赵鸿燕 , 刘承志 , 杜晓建 . 电渣重熔低Al钢过程中渣系对Al含量的影响 [J]. 铸造技术 , 2021 , 42 ( 10 ): 835 - 838 .
Okuyama G , Yamaguchi K , Takeuchi S , et al . Effect of slag composition on the kinetics of formation of Al 2 O 3 MgO inclusions in aluminum killed ferritic stainless steel [J]. ISIJ International , 2000 , 40 ( 2 ): 121 - 128 .
0
浏览量
0
下载量
0
CSCD
0
CNKI被引量
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621