50W1300冷轧无取向电工钢带的工业试制

特殊钢 ›› 2007, Vol. 28 ›› Issue (4): 45-47.

50W1300冷轧无取向电工钢带的工业试制

李士琦, 王忠诚, 赵宏, 刘润藻, 王玉刚

1北京科技大学冶金与生态工程学院，北京100083;
2中国国际工程咨询公司，北京100044

收稿日期:2006-01-06 出版日期:2007-07-01 发布日期:2023-01-06
作者简介:李士琦(1942-),男，博士生导师，冶金技术和工艺研究。

Commercial Pilot Production of 50W1300 Cold Rolled Non-Orientation Electrical Steel

Li Shiqi¹, Wang Zhongcheng^1,2, Zhao Hong¹, Liu Runzao¹, Wang Yugang¹

1 School of Metallurgical and Ecological Engineering, University of Science and Technology, Beijing 100083;
2 China International Engineering Consultation Co, Beijing 100044

Received:2006-01-06 Published:2007-07-01 Online:2023-01-06

摘要/Abstract

摘要： 采用40 t氧气顶吹转炉-180 mm×495 mm板坯连铸-连轧工艺流程,试制了0.5 mm×480 mm 3 t 50W1300冷轧电工钢带(铸坯成分%:0.04～0.06C、0.82～0.96Si、0.35～0.40Mn、0.015～0.017P、0.014～0.019S)。通过钢包吹氩,控制钢水终点温度1650～1670℃,钢中氧含量由72.9×10^-6降至22.9×10^-6。试制的冷轧无取向电工钢带成品的电磁性能和力学性能均达到GB/T2521-1996中50W1300标准要求,适用于小型电动机转子的制造。

Abstract: The 0.5 mm×480 mm 50W1300 non-oriented electrical steel sheet 3t (0.04～0.06C,0.82～0.96Si, 0.35~0.40Mn,0.015~0.017P,0.014~0.019S) has been researched and produced by using 40 t LD converter ·180 mm×495 mm slab concasting-continuous rolling flow sheet. The molten steel temperature was controlled between 1650 ℃ and 1670 ℃ and the oxygen content in steel decreased from72.9×10^-6to 22.9×10^-6by argon blowing in ladle. The electromagnetism properties and mechanical properties of pilot produced cold rolled non-orientation eclectic steel all met 50W1300 requirement of GB/T2521- 1996 being suitable for manufacturing rotor of small motor.

李士琦, 王忠诚, 赵宏, 刘润藻, 王玉刚. 50W1300冷轧无取向电工钢带的工业试制[J]. 特殊钢, 2007, 28(4): 45-47.

Li Shiqi, Wang Zhongcheng, Zhao Hong, Liu Runzao, Wang Yugang. Commercial Pilot Production of 50W1300 Cold Rolled Non-Orientation Electrical Steel[J]. Special Steel, 2007, 28(4): 45-47.