红外热像仪测定45钢常温黏性系数

特殊钢 ›› 2008, Vol. 29 ›› Issue (2): 34-36.

红外热像仪测定45钢常温黏性系数

刘浩¹赵军²

1太原科技大学应用科学学院，太原030024 ； 2北京化工大学机电工程学院，北京100029

出版日期:2008-04-01 发布日期:2023-01-19
作者简介:刘浩(1980-),男，硕士(北京化工大学)，2002年太原重型机械学院毕业，过程设备的强度和安全研究。

Determination of Viscosity Coefficient of 0.45C Steel by Infrared#br# Thermographic Sensor at Ambient Temperature#br#

Liu Hao¹ and Zhao Jun²

1 College of Applied Science, Taiyuan University of Science and Technology, Taiyuan 030024 ；
2 College of Mechanical and Electrical Engineering, Beijing University of Chemical Technology, Beijing 100029

Published:2008-04-01 Online:2023-01-19

摘要/Abstract

摘要： 通过高频疲劳试验机，用红外热像仪釆集45钢疲劳过程的热像图。记录3种工况下（I-载荷比r = -1；26.2 加载频率 137.8 Hz； U-拉伸平均应力σ_m =224 MPa,22.1℃,加载频率 141 Hz；Ⅲ-σ_m= 187 MPa, 27℃,加载频率138 Hz）试样表面温度的变化。求出不同频率疲劳过程非塑性效应下工作载荷与温升值的关系，得岀常温下45钢黏性系数F = 1 496.1 Pa • s。

关键词: 45钢 , 疲劳试验 , 常温黏性系数

Abstract: The thermographic figure of 0. 45 C steel during fatigue testing has been measured by high frequency fatigue testing machine using infrared thennographic sensor. The change of surface temperature of test sample was recorded at three load conditions - Nol- load ratio r = - 1 ； loading frequency 137. 8Hz at 26. 2℃； No2- average tensile stress σ_m= 224 MPa, loading frequency 141 Hz at 22. 1 ℃ ； No3- σ_m= 187 MPa, loading frequency 138 Hz at 27 °C. The relation between temperature rise value and service load below fatigue limit with different frequency during non-plastic test was derived and it was obtained that the viscosity coefficient of 0. 45C steel F=1 496.1 Pa·s.

Key words: 0. 45C Steel, Fatigue Test, Ambient Temperature Viscosity Coefficient

刘浩赵军. 红外热像仪测定45钢常温黏性系数[J]. 特殊钢, 2008, 29(2): 34-36.

Liu Hao and Zhao Jun. Determination of Viscosity Coefficient of 0.45C Steel by Infrared#br# Thermographic Sensor at Ambient Temperature#br#[J]. Special Steel, 2008, 29(2): 34-36.