CS100滑动水口机构在300t钢包上的应用

特殊钢 ›› 2009, Vol. 30 ›› Issue (4): 61-62.

CS100滑动水口机构在300t钢包上的应用

焦兴利

马鞍山钢铁股份有限公司第四钢轧总厂，马鞍山243000

收稿日期:2009-02-19 出版日期:2009-08-01 发布日期:2022-12-20
作者简介:焦兴利(1970-),男，博士生，高级工程师，炼钢工艺研究。

Application of CS100 Framework of Slide Gate Nozzle Used for 300 t Ladle

Jiao Xingli

No4 Steelmaking and Rolling General Works, Maanshan Iron and Steel Co Ltd,Maanshan 243000

Received:2009-02-19 Published:2009-08-01 Online:2022-12-20

摘要/Abstract

摘要： 马钢新区的生产流程为300t转炉-LF-RH-250mm×2150 mm CC。INTESTOP CS 100滑动水口机构最大标准浇注水口直径为100mm,用于300t钢包。生产实践表明,该滑板最大连用次数为6炉,每套机构平均使用600次,使用该机构可以显著降低操作费用,提升滑动水口的可靠性。介绍了INTERSTOP CS100滑动水口机构的主要技术参数,使用经验和使用过程存在的问题。

Abstract: Process flow sheet at new production area of Masteel is 300 t LD-LF-RH-250 mm×2150 mm CC line. The INTESTOP CS 100 framework of slide gate nozzle is used for 300 t ladle, of which the maximum standard casting nozzle diameter is 100 mm.Production practice showed that the maximum continuous-using number of times of slide gate was 6 heats,and the average using life of each set of framework was 600 times. Using the frameworks is available to obviously de- crease operation cost and improve reliability of slide gate nozzle. The main technical parameters of INTERSTOP CS 100 framework of slide gate nozzle,the using practice and existence problem during using process are presented in this article.

Key words: Ladle, Slide , Gate , Nozzle, Application

焦兴利. CS100滑动水口机构在300t钢包上的应用[J]. 特殊钢, 2009, 30(4): 61-62.

Jiao Xingli. Application of CS100 Framework of Slide Gate Nozzle Used for 300 t Ladle[J]. Special Steel, 2009, 30(4): 61-62.