单嘴精炼炉真空处理过程气泡行为及冶金效果研究

特殊钢 ›› 2010, Vol. 31 ›› Issue (5): 18-21.

单嘴精炼炉真空处理过程气泡行为及冶金效果研究

秦哲，朱梅婷，成国光，张鉴

北京科技大学冶金与生态工程学院，北京 100083

收稿日期:2010-05-13 出版日期:2010-10-01 发布日期:2022-11-11
作者简介:秦哲(1977-)，男，博士研究生，精炼、连铸研究。

A Study on Bubble Behavior during Vacuum Treatment of Refining Furnace with Single Snorkel and Metallurgical Effect

Qin Zhe , Zhu Meiting , Cheng Guoguang , Zhang Jian

School of Metallurgical and Ecological Engineering, University of Science and Technology, Beijing 100083

Received:2010-05-13 Published:2010-10-01 Online:2022-11-11

摘要/Abstract

摘要： 根据相似理论,以钢厂80 t单嘴精炼炉1:4的水模型模拟了单嘴精炼炉内气泡行为,分析了吹气流量(2～10 L/min)、吹气塞直径(15～30 mm)对气泡行为、混匀时间的影响。水模拟结果表明,随吹气流量增加,混匀时间减少,但吹气流量≥6 L/min,混匀时间没有显著变化;在相同吹气量下,吹气塞直径增加,混匀时间减少。实验研究基础上,在80 t单嘴精炼炉上进行了超低碳钢的生产试验,结果表明单嘴精炼炉在18 min脱碳时间内,钢中碳含量可降到10×10^-6;脱硫剂消耗4 kg/t的情况下,成品钢中S含量为(20～30)×10^-6,脱硫率平均达49%;吹氩强度平均为4 L/(t·min),是相同吨位RH的25%。

关键词: 单嘴精炼炉, 水模型, 气泡行为, 冶金效果

Abstract: According to similarity theory, the bubble behavior in single snorkel refining furnace has simulated by u- sing a scale 1 ：4 water model for an 80 t single snorkel refining furnace at steel works, and the effect of gas blowing rate (2~10 L/min) and plug diameter (15~30 mm) on bubble behavior and mixing time is analyzed. Water simulation results show that with increasing gas blowing rate the mixing time decreases, but as gas blowing rate >6 L/min, the mixing time has no obvious change ； at equal gas blowing rate, with increasing plug diameter the mixing time decreases. Based on water model experimental study, the pilot production of ultra-low carbon steel by an 80 t single snorkel refining furnace has been carried out. Results show that within decarburization time for 18 min in single snorkel refining furnace the carbon content in steel may decrease to 10 x 10^-6; at the condition of using 4 kg/t desulphurizing agent the sulphur content in finished steel is (20 - 30) x 10^-6 and the average desulphurizing rate is 49% ; the average argon blowing intensity is 4 L/(t • min) of a single snorkel refining furnace, it is 25% that of a RH unit with same capacity

Key words: Single Snorkel Refining Furnace, Water Model, Bubble Behavior, Metallurgical Effect

秦哲, 朱梅婷, 成国光, 张鉴. 单嘴精炼炉真空处理过程气泡行为及冶金效果研究[J]. 特殊钢, 2010, 31(5): 18-21.

Qin Zhe , Zhu Meiting , Cheng Guoguang , Zhang Jian. A Study on Bubble Behavior during Vacuum Treatment of Refining Furnace with Single Snorkel and Metallurgical Effect[J]. Special Steel, 2010, 31(5): 18-21.

[1]	李晓军, 陈景锋, 马骏鹏, 谭俊, 王伟. 浸入式水口结构对409 L钢连铸坯表面“卷渣”的影响[J]. 特殊钢, 2020, 41(3): 1-4.
[2]	刘启龙, 仇圣桃, 占树华, 王志政. 气体流量及水口底部形状对板坯结晶器内流场影响的水模型试验[J]. 特殊钢, 2018, 39(2): 1-5.
[3]	钟巍, 赵丹婷, 帅勇, 罗仁辉, 仇圣桃. 两流板坯连铸58t中间包过滤器的水模型试验和应用[J]. 特殊钢, 2018, 39(2): 13-16.
[4]	闫心怡, 沈明钢, 冯超. 300t 顶底复吹转炉氧枪枪位的水模型研究和应用[J]. 特殊钢, 2018, 39(1): 6-8.
[5]	张真铭, 蔡茜娜, 熊辉辉, 冯小明, 马鹏, 赖朝彬. 120 t钢包底吹氩工艺优化水模型研究[J]. 特殊钢, 2017, 38(4): 9-12.
[6]	邱春根, 时朋召, 徐李军, 仇圣桃, 赵鸿金. 250 mm x 1800 mm板坯连铸结晶器浸入式水口优化的物理模拟[J]. 特殊钢, 2017, 38(2): 11-15.
[7]	韩楚菲, 沈明钢, 杨晨. 工艺参数对120 t转炉顶底复吹影响的水模型研究和应用[J]. 特殊钢, 2017, 38(1): 1-3.
[8]	时朋召, 邱春根, 徐李军, 仇圣桃, 潘贻芳, 赖朝彬. 230 mm板坯连铸结晶器浸入式水口结构的优化[J]. 特殊钢, 2017, 38(1): 4-8.
[9]	赵丹婷, 刘爱强, 仇圣桃, 赖朝彬. 带过滤器63t中间包钢液流场的物理和数学模拟[J]. 特殊钢, 2016, 37(6): 22-26.
[10]	赵丹婷, 刘爱强, 仇圣桃, 赖朝彬. 通道式钢液过濾器对两流板坯连铸中间包流场的影响[J]. 特殊钢, 2016, 37(5): 17-21.
[11]	倪国龙, 艾立群, 赵定国, 冯聚, 王书桓. 基于示踪剂法板坯连铸40t中间包内钢液流动行为的物理模拟[J]. 特殊钢, 2016, 37(5): 26-31.
[12]	李明晖, 李远兵, 欧阳德刚, 王兴东, 邓品团, 张爱平. 100 t铁水脱硫顶吹辅助扒渣工艺水模型试验和应用[J]. 特殊钢, 2015, 36(5): 9-12.
[13]	包丽明, 吕国成, 刘坤. 180 t转炉底吹和顶-底复吹射流与熔池作用的水模型研究[J]. 特殊钢, 2015, 36(4): 9-12.
[14]	肖太平, 倪红卫, 孔勇江, 吴扬, 张华. 水口扩张角对230mm x 1300 mm板坯结晶器流场及氩气泡行为的影响[J]. 特殊钢, 2015, 36(2): 13-16.
[15]	包丽明, 刘坤, 吕国成. 180 t转炉聚合射流流场的水力学模型的实验研究[J]. 特殊钢, 2014, 35(3): 11-14.