关键词: 4Cr5MoSiV1, 探伤, 分析, 工艺改进

Abstract: The die steel 4Cr5MoSiV1 was produced with the path of hot metal + scrap→100 t EAF→double LF→ double VD→ round billet continuous casting (section Φ 500 mm)→ step reheating furnace→ 950 rolling mill,in the special steel division new district of Shandong Steel. There are defects in the detection of individual batches die steel 4Cr5MoSiV1. By using the ultrasonic testing to locate the defect location, and analyzing with the way of Metallographic analysis and scanning electron microscopy (SEM) , finally confirmed the center defect and the rolling compression ratio small are the main reasons of the testing substandard batch of steel 4Cr5MoSiV1, and the corresponding improved measures are put forward.