10t AOD冶炼Inconel 690合金的工艺实践

特殊钢 ›› 2019, Vol. 40 ›› Issue (4): 19-22.

10t AOD冶炼Inconel 690合金的工艺实践

张如金¹，刘仲礼²，武明²，徐志强¹，陈革¹

1烟台市台海玛努尔核电设备有限公司，烟台264000；
2烟台大学核装备与核工程学院，烟台264000

收稿日期:2019-02-15 出版日期:2019-08-01 发布日期:2022-05-14
作者简介:张如金(1986-)，男，硕士,(东北大学)，工程师，佳木斯大学(本科)毕业。

Technology Practice of Steelmaking Inconel 690 Alloy by a 10t AOD

Zhang Rujin¹ ,Liu Zhongli² ,Wu Ming², Xu Zhiqiang¹ ,Chen Ge¹

1 Yantai Taihai Manner Nclear Equipment Co Ltd,Yantai 264000;
2 School of Nuclear Equipment and Nuclear Engineering, Yantai University, Yantai 264000)

Received:2019-02-15 Published:2019-08-01 Online:2022-05-14

摘要/Abstract

摘要： 目前Inconel 690合金广泛用于核电站蒸汽发生器传热管。其通常采用真空感应炉冶炼自耗电极,冶炼成本较高。本研究通过对Inconel 690合金熔体的热力学分析和还原过程的讨论,认为采用电弧炉+氩氧精炼炉冶炼工艺路线,可以生产出满足标准要求的自耗电极。通过实践,表明此工艺可行,生产的自耗电极化学成分满足要求,气体含量低。为该产品的生产开辟了一条低成本、高效率的冶炼工艺路线。

Abstract: Inconel 690 alloy is widely used in steam generator heat transfer tubes in nuclear power plants. It usually u¬ses the vacuum induction furnace smelting consumable electrode,smelting cost is high. In this study,the thermodynamic analysis and reduction process of Inconel 690 alloy melt were discussed, and it was considered that the consumable electrode meeting the standard requirements could be produced by the arc furnace + argon oxygen refining furnace smelting process. The practice shows that the process is feasible, the chemical composition of the consumable electrode meets the requirements, and the gas content is low. For the production of the product opened up a low cost, high efficiency smelting process.

张如金, 刘仲礼, 武明, 徐志强, 陈革. 10t AOD冶炼Inconel 690合金的工艺实践[J]. 特殊钢, 2019, 40(4): 19-22.

Zhang Rujin , Liu Zhongli , Wu Ming, Xu Zhiqiang , Chen Ge. Technology Practice of Steelmaking Inconel 690 Alloy by a 10t AOD[J]. Special Steel, 2019, 40(4): 19-22.