真空热轧Q345B碳钢-304不锈钢复合板界面Cr、Ni扩散行为研究

特殊钢 ›› 2022, Vol. 43 ›› Issue (2): 27-30.

真空热轧Q345B碳钢-304不锈钢复合板界面Cr、Ni扩散行为研究

王光磊¹，党军¹，翟冬雨²，王昌民²

南京钢铁股份有限公司1研究院;2板材事业部，南京210035

收稿日期:2021-08-30 出版日期:2022-04-01 发布日期:2022-06-09
作者简介:王光磊(1986-)，男，博士(2014年东北大学)，工程师,2008年山东建筑大学(本科)毕业，复合钢板研发。
基金资助:
十三五国家重点研发计划项目(2017YFB0305004)

Research on Diffusion Behavior of Cr and Ni at Interface of Vacuum Hot-Rolled Q345B Carbon Steel-304 Stainless Steel Clad Plate

Wang Guanglei¹, Dang Jun¹, Zhai dongyuü² , Wang Changmin²

Nanjing Iron and Steel Co Ltd, 1 Research Institute；2 Plate Department,Nanjing 210035

Received:2021-08-30 Published:2022-04-01 Online:2022-06-09

摘要/Abstract

摘要： 研究了60 mm Q345B碳钢/10 mm 304不锈钢复合板坯在1 200℃仅加热不轧制及进行2倍压缩比轧制后30 mm Q345/5 mm 304复合界面Cr、Ni的扩散行为。试验结果表明,加热过程中,界面是否贴合并未影响扩散的进行,真空状态下不锈钢侧Cr、Ni发生蒸发逸出不锈钢并向碳钢侧发生了扩散,Cr扩散距离大于Ni。轧制后复合界面建立冶金结合,界面两侧浓度差异驱动Cr、Ni继续向碳钢侧扩散,初始加热扩散区被轧薄,复合界面两侧,Cr浓度差异小,Ni浓度差异大;2倍压缩比轧制后,不锈钢侧仅形成了宽度20μm的贫Cr区及10μm的贫Ni区。

Abstract: The diffusion behavior of Cr and Ni in the bonding interface of 60 nun Q345B carbon steel/10 mm 304 stainless steel clad plate being heated at 1 200 °C without rolling and being rolled to 30 mm Q345/5 mm 304 clad plate with 2 times compression ratio has been studied. The test results show that whether the interface contact or non-contact does not affect the diffusion during the heating process. Under the vacuum condition, Cr and Ni evaporate from the stainless steel side and diffuse to the carbon steel side, and tlie diffusion distance of Cr is greater than that of Ni. During the rolling process, the metallurgical bonding is established at the composite interface. The difference in the concentration of Cr and Ni on both sides of the interface drove the diffusion of Cr and Ni to the carbon steel side, and the initial heating diffusion zone is rolled and thinned. The concentration difference of Cr on both sides of the bonding interface is small while that of Ni is large. After 2 times compression ratio hot rolling, only 20μm width Cr and 10μm width Ni depletion zones are formed on the stainless steel side.

Key words: Q345B Carbon Steel-304 Stainless Steel Clad Plate, Hot-Rolled Bonding, Clad Interface, , Cr、Ni Diffusion, Depletion Zone

王光磊, 党军, 翟冬雨, 王昌民. 真空热轧Q345B碳钢-304不锈钢复合板界面Cr、Ni扩散行为研究[J]. 特殊钢, 2022, 43(2): 27-30.

Wang Guanglei, Dang Jun , Zhai dongyü , Wang Changmin. Research on Diffusion Behavior of Cr and Ni at Interface of Vacuum Hot-Rolled Q345B Carbon Steel-304 Stainless Steel Clad Plate[J]. Special Steel, 2022, 43(2): 27-30.

参考文献

[1]王子蒙，亢淑梅,徐美玲,等.316L/Q370qE复合板组织演变特征及腐蚀行为[J] .特殊钢,2019,40(4) =51-54.
[2]陈振业，马娥,朱文妙，等.非对称热轧单面不锈钢嗾钢复合板生产工艺研究[J].特殊钢,2018,39(6) =71-74.
[3]史豪杰，丁旭,罗海龙，等.异种有色金属复合板制备技术的研究进展[J].热加工工艺,2019,48(6):1-5.
[4]倪红卫，高娟,唐利民.不锈钢复合板制备技术的发展[J].特殊钢,2002,23(3):4-6.
[5]张成俊.爆炸夏合法制取金属复合板的现状探讨[J].煤矿爆破，2019,37(5) ：30-34.
[6]Ye C, Liu Q, Ni L, et al. Evaluation of Microstructure and Mechanical Properties of Explosive-welded Hsla/3041 Steel Bimetallic Plates [J]. Journal of Materials Engineering and Performance, 2020, 29 (8): 4944-4956.
[7]Wei Xiong, Malin Selleby, Qing Chen, et al. Phase Equilibria and Thermodynamic Properties in the Fe-cr System [J]. Critical Reviews in Solid State and Materials Sciences, 2010, 35(2) : 125-152.
[8]莫卫红.真空热处理中金属元素的蒸发冋题探讨[J].金属热处理,2001,26(1):27-28.
[9]Kubaschewski 0, Heymer G. The Thermodynamics of the Chromium- iron System [J]. Acta Metallurgica, 1960, 8(7): 416-423.
[10]庄鸿寿，Lugscheider E.不锈钢真空钎焊时的脱氧和润湿机理[J].焊接学报,1982,3(4) ：4-17,54-55.
[11]Leno M, Reinhard G, Paul B. Handbook of Thin Film Technology [J], 1971, 118(4)： 101-178.
[12]Jiang J, Ding H, Luo Z, et al. Interfacial Microstructure and Mechanical Properties of Stainless Steel Clad Plate Prepared By Vacuum Hot Rolling] J]. Journal of Iron and Steel Research International, 2018, 25(7)： 732-738.
[13]杨潇，郭帅,丁广飞，等.晶界结构对晶界扩散行为影响机理的研究[C]//中国稀土学会2017学术年会摘要集，2017： 87.
[14 ]陈树明,王海燕，姚兆凤，等.La在Fe基合金铁素体区的晶界扩散行为研究[J] .稀土,2018,39(6) ：34-39,