Test and Study on Pre-reduction of Stainless-Steel Dust at Intermediate and Low Temperature
|更新时间:2026-01-21
|
Test and Study on Pre-reduction of Stainless-Steel Dust at Intermediate and Low Temperature
Special SteelVol. 31, Issue 4, Pages: 7-10(2010)
作者机构:
上海大学现代冶金与材料制备重点实验室,上海,200072
作者简介:
基金信息:
DOI:
CLC:
Received:24 February 2010,
Online First:20 November 2022,
Published:20 November 2010
稿件说明:
移动端阅览
俞晓, 李秋菊, 任东霞, et al. Test and Study on Pre-reduction of Stainless-Steel Dust at Intermediate and Low Temperature[J]. Special Steel, 2010, 31(4): 7-10.
DOI:
俞晓, 李秋菊, 任东霞, et al. Test and Study on Pre-reduction of Stainless-Steel Dust at Intermediate and Low Temperature[J]. Special Steel, 2010, 31(4): 7-10.DOI:
Test and Study on Pre-reduction of Stainless-Steel Dust at Intermediate and Low Temperature
Main analysis of stainless-steel dust with intermediate size 1. 78μm is (% :) 41.0Fe
3.3Ni
24.80
2. 6Cr
4.1Ca
3. 6Zn
of which the main mineralogy is Fe
3
O
4
FeO • Cr
2
O
3
and CrO. The effect of gas-solid ratio (1.6- 4. 0 L/g)
reduction time (50 ~300 s)
CO fraction in H
2
-CO mix gas (20% ~60%) and temperature (500 〜700 ℃) on reduction rate of stainless-steel oxides has been studied. Orthogonal test results show that the gas-solid ratio has most obvious effect in four factors
following in sequence being reduction mix gas ingredient
reduction time and reaction temperature. The reduction rate of stainless-steel dust is up to 50% in 5 min with gas-solid ration 4. 0 L/g