Finite Element Analysis on Bending Deformation of 100-Meter U75V Steel Rail during Cooling Process before Straightening

李革; 贾宝华; 姜旭

您当前的位置：

首页 >

文章列表页 >

Finite Element Analysis on Bending Deformation of 100-Meter U75V Steel Rail during Cooling Process before Straightening

更新时间：2026-01-21

- Finite Element Analysis on Bending Deformation of 100-Meter U75V Steel Rail during Cooling Process before Straightening
- Special Steel Vol. 31, Issue 3, Pages: 14-15(2010)
- 作者机构：
  
  内蒙古科技大学建筑与土木工程学院,包头,014010
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：19 December 2009，
  
  Online First：07 November 2022，
  
  Published：07 November 2010
- 稿件说明：
移动端阅览
李革, 贾宝华, 姜旭. Finite Element Analysis on Bending Deformation of 100-Meter U75V Steel Rail during Cooling Process before Straightening[J]. Special Steel, 2010, 31(3): 14-15.
DOI：

李革, 贾宝华, 姜旭. Finite Element Analysis on Bending Deformation of 100-Meter U75V Steel Rail during Cooling Process before Straightening[J]. Special Steel, 2010, 31(3): 14-15. DOI：

摘要

通过研究百米钢轨冷却的边界条件

采用三维瞬态非线性有限元法计算分析了百米U75V平直钢轨矫直前冷却过程中的弯曲变形变化规律。结果表明

平直钢轨在冷却过程中的弯曲变形是一个循环反复的过程

但钢轨最终是弯向轨头的;在考虑钢轨与冷床摩擦作用的情况下

平直钢轨终冷后

其变形特点是中间平直、两端弯曲

端部弯曲范围约为18 m。

Abstract

The regularity of bending of 100 m U75V steel straight rail during cooling process before straightening has been calculated by analyzing the boundary conditions of cooling of 100 m rail and using three-dimensional instantaneous non-linear finite element method. Results show that the bending deformation of the straight steel rail during cooling process is a repeat-cycling process

but the rail eventually is bent to the rail head ； with considering the friction between steel rail and cooling bed

after the straight steel rail finishing cooling the deforming feature of rail is straight at middle part

bent at both ends and scope of bent ends covering 18 m.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰