Effect of Boron on Structure and Mechanical Properties of 50 mm Plate of Steel 07 MnNiMoVDR for Cryogenic Spherical Tank

王黎; 吴涛

您当前的位置：

首页 >

文章列表页 >

Effect of Boron on Structure and Mechanical Properties of 50 mm Plate of Steel 07 MnNiMoVDR for Cryogenic Spherical Tank

更新时间：2026-01-21

- Effect of Boron on Structure and Mechanical Properties of 50 mm Plate of Steel 07 MnNiMoVDR for Cryogenic Spherical Tank
- Special Steel Vol. 34, Issue 6, Pages: 59-61(2013)
- 作者机构：
  
  1. 内蒙古伊泰集团有限公司,鄂尔多斯,017000
  2. 舞阳钢铁有限责任公司科技部，舞钢,462500
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：11 July 2013，
  
  Online First：08 September 2022，
  
  Published：08 September 2013
- 稿件说明：
移动端阅览
王黎, 吴涛. Effect of Boron on Structure and Mechanical Properties of 50 mm Plate of Steel 07 MnNiMoVDR for Cryogenic Spherical Tank[J]. Special Steel, 2013, 34(6): 59-61.
DOI：

王黎, 吴涛. Effect of Boron on Structure and Mechanical Properties of 50 mm Plate of Steel 07 MnNiMoVDR for Cryogenic Spherical Tank[J]. Special Steel, 2013, 34(6): 59-61. DOI：

摘要

低温球罐用钢07MnNiMoVDR(/%:0.06~0.08C、0.20~0.30Si、1.50~1.60Mn、0.30~0.40Ni、0.10~0.15Cr、0.18~0.25Mo、0.04~0.05V、0.02~0.04Al)50 mm板由100 t UHP EAF-LF-300 mm×2 000 mm CC-4辊可逆轧机轧制工艺生产。研究了0~0.002 0%B对该钢900℃淬火-620℃回火的50 mm板组织和力学性能的影响。结果表明

加硼能显著提高钢板淬透性

以钢板心部得到均匀贝氏体为主的组织;当硼含量超过0.001 5%时

组织粗大并有混晶出现

冲击功下降

抗拉强度750 MPa超出标准上限(730 MPa)。当钢中硼含量控制在0.0005%~0.001 5%时钢板有良好的强韧性匹配

抗拉强度R

为630~690 MPa

冲击功140~275 J

满足标准要求。

Abstract

The 50mm plate of steel 07MnNiMoVDR (/% : 0. 06 ~0. 08C

0. 20 ~0.30Si

1. 50 ~ 1. 60Mn

0.30 ~0. 40Ni

0. 10 ~0. 15Cr

0. 18 ~0. 25Mo

0. 04 ~0. 05V 0. 02 ~0. 04Al) for cryogenic spherical tank is produced by 100 t UHP EAF-LF-300 mm x 2 000 mm CC-four-high reversing mill rolling process. The Effect of 0 ~ 0. 002 0% B on structure and mechanical properties of 50 mm plate of the steel quenched at 900 °C -tempered at 620℃ has been studied. Results show that adding boron can obviously increase hardenability of plate to get homogeneous major bainite structure ； as the boron content in steel is more than 0.001 5%

the structure coarsens with occurrence of mixing grains led to impact energy decreasing and tensile strength of steel (750 MPa) larger than the upper limit of standard (730 MPa). As the boron content in steel is controlled in 0.000 5% ~0.001 5%

the steel plate has excellent strength-toughness matching i. e. tensile strength 630 ~690 MPa and impact energy 140 ~ 275 J to meet the standard requirement.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Structure and Properties of Coarse Grain Heat Affected Zone of Zr Microalloying HSLA Steel

Effect of Deformation on Structure and Mechanical Properties of Non-Orientation Silicon Steel 50W470

Effect of Cold Rolling and Solid Solution Treatment on Structure and Mechanical Properties of Modified Type 202 Stainless Steel

An Analysis on Strengthening Factors and Mechanical Properties of Q345B Steel Strip Produced by CSP Process

Effect of Annealing Process on Structure and Properties of 0.17C Cold Rolled Steel Sheet for Chain

Related Author

习天辉

陈晓

陈颜堂

浦绍康

孙述利

郭东城

刘江

宋文军

Related Institution

武汉钢铁(集团)公司技术中心

太原科技大学材料学院

太原钢铁有限公司

武钢集团技术中心

武钢集团海南公司

⁰