Experimental Study on Hot Deformation Behavior and Math Models for Deformation Resistance of EA4T Axle Steel for High Speed Rail

徐刚; 李士琦; 王乐; 刘奇

您当前的位置：

首页 >

文章列表页 >

Experimental Study on Hot Deformation Behavior and Math Models for Deformation Resistance of EA4T Axle Steel for High Speed Rail

更新时间：2026-01-21

- Experimental Study on Hot Deformation Behavior and Math Models for Deformation Resistance of EA4T Axle Steel for High Speed Rail
- Special Steel Vol. 34, Issue 3, Pages: 60-63(2013)
- 作者机构：
  
  北京科技大学冶金与生态工程学院,北京,100083
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：18 December 2012，
  
  Online First：22 September 2022，
  
  Published：22 September 2013
- 稿件说明：
移动端阅览
徐刚, 李士琦, 王乐, et al. Experimental Study on Hot Deformation Behavior and Math Models for Deformation Resistance of EA4T Axle Steel for High Speed Rail[J]. Special Steel, 2013, 34(3): 60-63.
DOI：

徐刚, 李士琦, 王乐, et al. Experimental Study on Hot Deformation Behavior and Math Models for Deformation Resistance of EA4T Axle Steel for High Speed Rail[J]. Special Steel, 2013, 34(3): 60-63. DOI：

摘要

试验用EA4T车轴钢(/%:0.26C、0.35Si、0.75Mn、0.011P、0.012S、1.04Cr、0.22Mo)由10 kg真空感应炉熔炼。用Gleeble-1500热模拟试验机对EA4T车轴钢进行高温单道次压缩试验以研究温度(950～1150℃)、应变量(0～0.8)和应变速率(0.1～20 s

-1

)对该钢变形抗力的影响

并建立该钢热变形抗力的数学模型。结果表明

钢种在较高温度和较低应变速率下动态再结晶容易发生

峰值应力(σ

)、峰值应变(ε

)和稳态应力(σ

)与参数lnZ成线性关系;实验钢的峰值与稳态激活能分别为320.22 kJ/mol和361.91 kJ/mol;变形抗力的预测模型与实验所得结果吻合良好。

Abstract

Tested EA4T axle steel (/% : 0. 26C

0. 35Si

0. 75Mn

0. 01 IP

0. 012S

1. 04Cr

0. 22Mo) is melted by a 10 kg vacuum induction furnace. The single pass reduction test on tested EA4T axle steel is carried out by using Gleeble-1500 thermal simulation machine to study the effect of temperature (950 ~ 1 150℃)

strain (0 ~0. 8) and strain rate (0. 1 - 20 s

-1

) on deformation resistance of this steel

and the a math model for hot deformation resistance of the steel is established. Results show that the dynamic recrystallization of the steel easily occurs at higher temperature and lower strain rate

its peak stress (σ

)

peak strain ( ε

) and steady strain (σ

) of test steel are all in linear relationship with parameter InZ； th

e peak and steady activation energy of test steel is respectively 320. 22 kJ/mol and 361. 91 kJ/mol ； and the deformation resistance calculated by predicted model is in good agreement with measured result.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of Hot Rolling Parameters on Deformation Resistance of Coarse-Grained Niobium Steel

Hot Deformation Behavior of 2507 Super Duplex Stainless Steel

Development of Secondary Cooling Water Distribution Model for Large-Size Round Bloom Casting

A Study on Recrystallization of Fluoride Free Titanium Bearing Solidified Flux Film of Casting Powder in Mold

Study on Regularity of Temperature Reduction of IF Steel Slab Casting Liquid with 210 t Top and Bottom Combined Blown Converter-RH Flow Sheet

Related Author

刘清友

孙新军

文建华

雷霆

阴树标

花福安

刘丽丽

王佳夫

Related Institution

钢铁研究总院结构材料研究所

昆明理工大学材料与冶金工程学院

东北大学轧制技术及连轧自动化国家重点实验室

烟台宝钢钢管有限责任公司

中冶京诚工程技术有限公司

⁰