Research on Melting of Molybdenum-Bearing Hot Metal by Injecting Molybdenum Oxide Powder

张永亮; 王建昌; 王彦平; 翟俊

您当前的位置：

首页 >

文章列表页 >

Research on Melting of Molybdenum-Bearing Hot Metal by Injecting Molybdenum Oxide Powder

更新时间：2026-01-21

- Research on Melting of Molybdenum-Bearing Hot Metal by Injecting Molybdenum Oxide Powder
- Special Steel Vol. 39, Issue 4, Pages: 5-8(2018)
- 作者机构：
  
  1. 山西太钢不锈钢股份有限公司,太原,030003
  2. 太原钢铁(集团)有限公司先进不锈钢材料国家重点实验室,太原,030003
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：08 February 2018，
  
  Online First：31 May 2022，
  
  Published：31 May 2018
- 稿件说明：
移动端阅览
张永亮, 王建昌, 王彦平, et al. Research on Melting of Molybdenum-Bearing Hot Metal by Injecting Molybdenum Oxide Powder[J]. Special Steel, 2018, 39(4): 5-8.
DOI：

张永亮, 王建昌, 王彦平, et al. Research on Melting of Molybdenum-Bearing Hot Metal by Injecting Molybdenum Oxide Powder[J]. Special Steel, 2018, 39(4): 5-8. DOI：

摘要

研究了铁水成分、温度条件下氧化钼的还原反应热力学

并在80 t铁水脱硅、脱磷预处理工序进行了多炉喷吹氧化钼粉工艺试验

试验确定了合理的喷吹氧化钼粉工艺参数

氧化钼粉粒度0.10～0.15 mm

喷吹时间30～35 min

对应喷吹流量3.0～3.5 kg/min

试验炉次氧化钼粉中钼的收得率达98%以上。

Abstract

The theoretic calculations were performed on reduction thermodynamic of molybdenum oxide powder based on different chemical composition and temperature of hot metal. The scale-up experiments were carried out at 80 t hot metal ladle and results indicate that yield of molybdenum will reaches over 98% by adopting such technical parameters as the size distribution of molybdenum oxide powder being；0. 10 - 0. 15 mm

injection time being 30 ~ 35 min

injection rate being 3

0 ~ 3. 5 kg/min.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Commercial Experiment of Steelmaking Steel B7 and 42CrMoA by llOt BOF Molybdenum Oxide Direct Reduction Alloying

Related Author

秦凤婷

刘宗辉

Related Institution

济源职业技术学院冶金化工系

河南济源钢铁(集团)有限公司炼钢厂

⁰