Effect of Annealing Temperature on Microstructure and Hardness of Cutting Steel 6CrW2Si

刘向艳; 杨建华; 康湉; 翟军; 刘桂江; 马群革; 穆立峰

您当前的位置：

首页 >

文章列表页 >

Effect of Annealing Temperature on Microstructure and Hardness of Cutting Steel 6CrW2Si

更新时间：2026-01-21

- Effect of Annealing Temperature on Microstructure and Hardness of Cutting Steel 6CrW2Si
- Special Steel Vol. 39, Issue 4, Pages: 63-65(2018)
- 作者机构：
  
  1. 抚顺特殊钢股份有限公司连轧厂,抚顺,113001
  2. 抚顺特殊钢股份有限公司初轧厂,抚顺,113001
  3. 抚顺特殊钢股份有限公司技术处,抚顺,113001
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：28 February 2018，
  
  Online First：01 June 2022，
  
  Published：01 June 2018
- 稿件说明：
移动端阅览
刘向艳, 杨建华, 康湉, et al. Effect of Annealing Temperature on Microstructure and Hardness of Cutting Steel 6CrW2Si[J]. Special Steel, 2018, 39(4): 63-65.
DOI：

刘向艳, 杨建华, 康湉, et al. Effect of Annealing Temperature on Microstructure and Hardness of Cutting Steel 6CrW2Si[J]. Special Steel, 2018, 39(4): 63-65. DOI：

摘要

为满足用户加工硬度的特殊需求(硬度≤210HBW)

降低6CrW2Si钢硬度

本文利用连轧厂实际辊底式退火炉进行了不同退火温度的退火试验

并借助金相显微镜对不同退火温度下的组织进行了分析

以确定最佳的退火温度。结果表明:6CrW2Si的退火硬度与退火温度有关

随着退火温度的升高

硬度先下降后上升

当退火温度为810℃时

钢材平均硬度值最低(193 HBW左右)

球化组织为均匀的球化珠光体组织。

Abstract

Tests were annealed under different temperature

for purchasers word-hardness( ≤210 HBW) special requirements satisfaction to determine the eptimal annealing process with the help of metalloscope to analyze annealing shape of 6CrW2Si under different temperature. The result showed that 6CrW2Si annealing hardness was connected with temperature

with the increase of annealing temperature

the hardness dacreases first and then increases. When annealing temperature is 810℃

the average hardness of steel products is the lowest( adout 193 HBW) and the structure is uniform spheroidized pearlite.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of Deformation and Cooling Rate on Deformation-Induced Ferrite Transformation in SCM435 Cold Heading Steel

Influence of Cold Rolling Reduction and Annealing Temperature on Properties of Ti-IF Steel

Influence of Cold Rolling Reduction and Annealing Temperature on Texture and Formability of Ti-IF Steel

Effect of Heat Treatment on Structure and Properties of Spraying Formed Bearing Steel GCr15

Effect of Si on Metallurgical Quality, Structure and Properties of Semi-High-Speed Steel 5Cr5WMoSiV

Related Author

马健

王宝山

张宏亮

马洪磊

薛正国

杨栋

冯光宏

陈继林

Related Institution

河北省线材工程技术研究中心

邢台钢铁有限责任公司

钢铁研究总院冶金工艺研究所

广西柳州钢铁(集团)公司

武汉科技大学材料加工工程系

⁰