Analysis on Quenching Delamination Crack of 150mm Cladding Plates of Low Carbon Alloy Steel SA387GrllCL2 and Process Improvement

侯美伶; 张艳; 孔祥伟; 陈青江; 阳日隆

您当前的位置：

首页 >

文章列表页 >

Analysis on Quenching Delamination Crack of 150mm Cladding Plates of Low Carbon Alloy Steel SA387GrllCL2 and Process Improvement

更新时间：2026-01-21

- Analysis on Quenching Delamination Crack of 150mm Cladding Plates of Low Carbon Alloy Steel SA387GrllCL2 and Process Improvement
- Special Steel Vol. 41, Issue 2, Pages: 28-31(2020)
- 作者机构：
  
  1. 江阴兴澄特种钢铁有限公司 1特板事业部
  2. 研究院，江阴,214400
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Received：25 October 2019，
  
  Online First：21 April 2022，
  
  Published：21 April 2020
- 稿件说明：
移动端阅览
侯美伶, 张艳, 孔祥伟, et al. Analysis on Quenching Delamination Crack of 150mm Cladding Plates of Low Carbon Alloy Steel SA387GrllCL2 and Process Improvement[J]. Special Steel, 2020, 41(2): 28-31.
DOI：

侯美伶, 张艳, 孔祥伟, et al. Analysis on Quenching Delamination Crack of 150mm Cladding Plates of Low Carbon Alloy Steel SA387GrllCL2 and Process Improvement[J]. Special Steel, 2020, 41(2): 28-31. DOI：

摘要

采用2块365mm复合坯轧制成150mm厚钢板

该板经淬火和回火处理后

火焰切割四边时发现在1/2厚度处出现分层开裂。分析结果表明

调质分层开裂是由中心复合面处存在的夹杂物和调质时的淬火应力综合作用导致的。当复合坯焊接的真空度由5×10

-2

Pa降低到1×10

-2

Pa时

复合面处未发现夹杂物

调质复合板1/2厚度处未出现分层开裂现象。

Abstract

The 150 mm thick steel cladding plate is rolled by two block 365 mm cladding bloom

the delamination crack at 1/2 thickness of quenched-tempered cladding plate occurs when cutting four sides by flame. Analysis results show that quenching delamination crack is induced by the inclusions in central cladding interface together with the quenching stress. When the cladding bloom welding vacuum decreases from 5 x 10

-2

Pa to 1 x 10

-2

the cladding plate is not found inclusions in cladding interface and the delamination crack at 1/2 thickness cladding plate does not occur.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰