Influence of ESR Slag on Cleanness of GCr15 Bearing Steel

肖爱平; 张洲; 李德胜; 汪质刚; 董艳伍

doi:10.20057/j.1003-8620.2022-00137

您当前的位置：

首页 >

文章列表页 >

Influence of ESR Slag on Cleanness of GCr15 Bearing Steel

更新时间：2026-01-21

- Influence of ESR Slag on Cleanness of GCr15 Bearing Steel
- Special Steel Vol. 43, Issue 6, Pages: 34-37(2022)
- 作者机构：
  
  1. 大冶特殊钢有限公司技术中心,黄石,435001
  2. 东北大学冶金学院,沈阳,110819
- 作者简介：
- 基金信息：
- DOI：10.20057/j.1003-8620.2022-00137
  CLC：
- Received：08 September 2022，
  
  Online First：18 November 2022，
  
  Published：18 November 2022
- 稿件说明：
移动端阅览
肖爱平, 张洲, 李德胜, et al. Influence of ESR Slag on Cleanness of GCr15 Bearing Steel[J]. Special Steel, 2022, 43(6): 34-37.
DOI：

肖爱平, 张洲, 李德胜, et al. Influence of ESR Slag on Cleanness of GCr15 Bearing Steel[J]. Special Steel, 2022, 43(6): 34-37. DOI： 10.20057/j.1003-8620.2022-00137.

摘要

针对目前在电渣重熔(ESR)GCr15轴承钢D类夹杂物超标问题，设计不同渣系，并分别借助Factsage软件和经验公式计算了渣系的熔化特性、黏度、电导率等物性参数，采用实验室渣金平衡实验及现场2.5 t电渣重熔实验分析得出：最优ESR渣系为55CaF

-25Al

-15CaO-5MgO。使用新渣系平均全氧含量较传统渣系降低41.98%

并且能够降低电渣锭不同位置的全氧含量；对于1～5μm夹杂物个数较原始渣系下降了31.25%。通过渣系对夹杂物调控，改善了GCr15轴承钢中D类夹杂物，评级级别可达到0.5级，能够更好地“净化”电渣锭。

Abstract

In accordance with the current in electroslag remelting(ESR)GCr15 bearing steel D inclusions exceeding the standard problem

the different slag systems are designed

and respectively with the help of Factsage software and empirical formulae to calculate the melting characteristics of the slag system

viscosity

electrical conductivity and other physical parameters

using laboratory slag metal balance experiments and field 2.5 t electroslag remelting experiments

the results show that

the optimal ESR slag system is 55CaF

-25Al

- 15CaO-5MgO.With use of the optimal slag system the average total oxygen content in steel is 41.98% lower than that with the traditional slag system

and can reduce the change in the total oxygen content of steel in different locations of electroslag ingot; as compared

to the original slag system the number of 1-5 μm inclusions decreases by 31.25%.Through the slag system on inclusions control

it can improve class D inclusion in GCr15 bearing steel

rating level reaches 0.5

and can better“clean”electric slag ingot.

关键词

Keywords

references

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of Aluminum Content on Microstructure and Properties of Fe-1.4C-1.5Cr-Alx Steel

Low-cost Non-vacuum Induction Furnace Smelting of High Molybdenum Content of Nickel-base Alloy

Development of Voltage Swing Control System of 15 t Consarc ESR Furnace

An Analysis on Micro-Inclusion in Bearing Steel at Each Procedure of BOF-LF-VD-CC Flow Sheet

Practice of Process for Decreasing Large Size Globular Oxides Inclusion (Ds) in Bearing Steel and Gear Steel

Related Author

Cao Wenquan

Yu Feng

Zhang Wanli

Wang Hui

Shi Dafang

Yang Jun

Liu Dong

Guo Jing

Related Institution

Zhejiang Tianma Bearing Co.， Ltd.

Research Institute of Special Steels， Central Iron and Steel Research Institute Co.， Ltd.

Technical Centre， Fushun Special Steel Co.， Ltd.

清华大学自动化系

冶金自动化研究设计院

⁰