Effect of Progressive Solid Solution Treatment on the Structure and Properties of 316H Stainless Steel

Jing Xue; Xin Guanghan; Geng Xin; Jiang Zhouhua

doi:10.20057/j.1003-8620.2024-00102

您当前的位置：

首页 >

文章列表页 >

Effect of Progressive Solid Solution Treatment on the Structure and Properties of 316H Stainless Steel

Forming and Phase Transition | 更新时间：2025-05-09

- Effect of Progressive Solid Solution Treatment on the Structure and Properties of 316H Stainless Steel
- Special Steel Vol. 46, Issue 1, Pages: 99-105(2025)
- 作者机构：
  
  东北大学冶金学院，沈阳 110819
- 作者简介：
- 基金信息：
- DOI：10.20057/j.1003-8620.2024-00102
  CLC： TG142
- Received：22 April 2024，
  
  Published：30 January 2025
- 稿件说明：
移动端阅览
荆雪,辛光瀚,耿鑫等.渐进式固溶处理对316H不锈钢组织及性能的影响[J].特殊钢,2025,46(01):99-105.

Jing Xue,Xin Guanghan,Geng Xin,et al.Effect of Progressive Solid Solution Treatment on the Structure and Properties of 316H Stainless Steel[J].Special Steel,2025,46(01):99-105.
荆雪,辛光瀚,耿鑫等.渐进式固溶处理对316H不锈钢组织及性能的影响[J].特殊钢,2025,46(01):99-105. DOI： 10.20057/j.1003-8620.2024-00102.

Jing Xue,Xin Guanghan,Geng Xin,et al.Effect of Progressive Solid Solution Treatment on the Structure and Properties of 316H Stainless Steel[J].Special Steel,2025,46(01):99-105. DOI： 10.20057/j.1003-8620.2024-00102.

摘要

针对316H奥氏体不锈钢中残余铁素体含量≤1%与晶粒尺寸大小控制在4～6级的要求。基于Thermo-calc热力学计算和固溶处理过程中组织性能变化规律研究，提出了渐进式固溶处理方法。热力学计算结果显示，316H钢形成单一奥氏体组织的固溶温度为975.5～1 281 ℃。固溶实验研究显示，单段固溶处理的实验钢在1 050、1 100 ℃时，即可满足残余铁素体含量要求，但1 100 ℃时晶粒大小分布不均匀，混晶现象严重，导致实验钢塑性和韧性增高，但强度明显下降。采用1 000 ℃（1 h）+1 100 ℃（1 h）渐进式固溶处理，在保证铁素体含量和晶粒尺寸满足要求前提下，使得组织均匀性得到明显改善，强韧性高于单段固溶处理样品。

Abstract

Regarding the requirement of residual ferrite content not exceeding 1% and grain size controlled within 4-6 levels in 316H austenitic stainless steel. Based on Thermo calc thermodynamic calculations and research on the changes in microstructure and properties during solid solution treatment， a progressive solid solution treatment method is proposed. The thermodynamic calculation results show that the solid solution temperature range for the formation of a single austenite structure in 316H steel is 975.5 ℃-1 281 ℃.Solid solution experimental research shows that the experimental steel treated with single stage solid solution can meet the requirements for residual ferrite content at 1 050 ℃ and 1 100 ℃， but the distribution of grain size is uneven and the phenomenon of mixed crystals is severe， leading to an increase in plasticity and toughness of the experimental steel， but the strength is obviously decreased. Adopting a progressive solid solution treatment of 1 000 ℃ （1 h）+1 100 ℃ （1 h）， while ensuring that the ferrite content and grain size meet the requirements， the uniformity of the structure is significantly improved， and the strength and toughness of the sample are higher than those of single stage solid solution treatment.

关键词

Keywords

references

He S ， Shang H ， Fernández-Caballero A ， et al . The role of grain boundary ferrite evolution and thermal aging on creep cavitation of type 316H austenitic stainless steel ［J］. Materials Science and Engineering： A ， 2021 ， 807 ： 140859 .

Zhao L ， Qi X Y ， Xu L Y ， et al . Tensile mechanical properties， deformation mechanisms， fatigue behaviour and fatigue life of 316H austenitic stainless steel： Effects of grain size ［J］. Fatigue & Fracture of Engineering Materials & Structures ， 2021 ， 44 （ 2 ）： 533 - 550 .

Li X L ， Chang L T ， Liu C P ， et al . Effect of thermal aging on corrosion behavior of type 316H stainless steel in molten chloride salt ［J］. Corrosion Science ， 2021 ， 191 ： 109784 .

L.L. Guo ， Q. Liu ， H.Q. Yin ， T.J. Pan ， Z.F. Tang ， Excellent corrosion resistance of 316 stainless steel in purified NaCl-MgCl2 eutectic salt at high temperature， Corros . Sci . 166 （ 2020 ）.

Dai Y N ， Zheng X T ， Ding P S . Review on sodium corrosion evolution of nuclear-grade 316 stainless steel for sodium-cooled fast reactor applications ［J］. Nuclear Engineering and Technology ， 2021 ， 53 （ 11 ）： 3474 - 3490 .

Sarvghad M ， Delkasar Maher S ， Collard D ， et al . Materials compatibility for the next generation of Concentrated Solar Power plants ［J］. Energy Storage Materials ， 2018 ， 14 ： 179 - 198 .

Wang Q Y ， Chen S H ， Rong L J . δ-ferrite formation and its effect on the mechanical properties of heavy-section AISI 316 stainless steel casting ［J］. Metallurgical and Materials Transactions A ， 2020 ， 51 （ 6 ）： 2998 - 3008 .

李建民，庄　迎，尹　嵬 . 316H不锈钢铁素体的形成与控制［J］. 钢铁， 2022 ， 57 （ 11 ）： 123 - 130 .

Suutala N ， Takalo T ， Moisio T . The relationship between solidification and microstructure in austenitic and austenitic-ferritic stainless steel welds ［J］. Metallurgical Transactions A ， 1979 ， 10 （ 4 ）： 512 - 514 .

Ben Rhouma A ， Amadou T ， Sidhom H ， et al . Correlation between microstructure and intergranular corrosion behavior of low delta-ferrite content AISI 316 L aged in the range 550–700 ℃ ［J］. Journal of Alloys and Compounds ， 2017 ， 708 ： 871 - 886 .

尹　嵬，梁　伟 . 热处理工艺对316H不锈钢中厚板力学性能影响研究［J］. 特殊钢， 2019 ， 40 （ 1 ）： 60 - 62 .

陈胜虎，王琪玉，姜海昌，戎利建． δ-铁素体对钠冷快堆用316KD奥氏体不锈钢热变形行为和动态再结晶的影响［J］，金属学报 .

Inoue H ， Koseki T . Solidification mechanism of austenitic stainless steels solidified with primary ferrite ［J］. Acta Materialia ， 2017 ， 124 ： 430 - 436 .

Koseki T ， Flemings M C . Solidification of undercooled Fe-Cr-Ni alloys： Part II. Microstructural evolution ［J］. Metallurgical and Materials Transactions A ， 1996 ， 27 （ 10 ）： 3226 - 3240 .

Padilha A F ， Tavares C F ， Martorano M A . Delta ferrite formation in austenitic stainless steel castings ［J］. Materials Science Forum ， 2013 ， 730-732 ： 733 - 738 .

Views

下载量

CSCD

CNKI被引量

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of Cr Content on the Microstructure and Mechanical Properties of 0.03C-XCr-14Ni-2.3Mo-0.35Nb-Fe Austenitic Stainless Steel

Effect of Solution Temperature on Microstructural Evolution and Tensile Properties of Hot-rolled Haynes 230 Alloy Bar

Effect of Quenching Temperature on Mechanical Properties of M₆C Reinforced 2 200 MPa Ultra-high Strength Steel

Influence of Microstructure on DWTT Performance of Thin-wall X65M Pipeline Steel

Verification and Application of Austenite Grain Growth Model in 34CrNi3MoV Steel

Related Author

Wang Ping

Xu Yang

Yi Haoyu

Jiang Yuefeng

Liang Rui

Liang Tian

Ma Yingche

Wei Hang

Related Institution

Shi Changxu Innovation Materials Research Center， Institute of Metal Research， Chinese Academy of Sciences

CGN Nuclear Power Research Institute Co.， Ltd.

Key Laboratory of Nuclear Materials and Safety Evaluation， Institute of Metal Research， Chinese Academy of Sciences

Key Laboratory of Electromagnetic Processing of Materials， Ministry of Education， Northeastern University

Wuxi Paike New Materials Technology Co.， Ltd.

⁰