热处理工艺对100mm特厚07MnCrMoVR水电钢板组织性能的影响

特殊钢 ›› 2020, Vol. 41 ›› Issue (2): 62-65.

热处理工艺对100mm特厚07MnCrMoVR水电钢板组织性能的影响

冯路路^1,2，乔文玮³, 鲁修宇⁴

1荆楚理工学院机械工程学院，荆门448000 ；
2武汉科技大学高性能钢铁材料及其应用省部共建协同创新中心，武汉430081:
3江苏华能电缆股份有限公司，高邮225613 ；
4武汉钢铁(集团)研究院，武汉430080

收稿日期:2019-11-08 出版日期:2020-04-01 发布日期:2022-04-22
作者简介:冯路路(1982-)，男，硕士(2008年东北大学)，高级工程师， 2005年沈阳理工大学(本科)毕业，高性能金属材料及强韧化研究。

Effect of Heat Treatment Process on Microstructure and Properties of 100 mm Ultra-thick 07MnCrMoVR Hydropower Steel Plate

Feng Lulu^1,2, Qiao Wenwei³ , Lu Xiuyu⁴

1 School of Mechanical Engineering, Jing Chu University of Technology, Jingmen 448000；
2 Collaborative Innovation Center for Advanced Steels, Wuhan University of Science and Technology, Wuhan 430081 ；
3 Jiangsu Huaneng Cable Co Ltd, Gaoyou 225613；
4 Research Institute of Wuhan Iron & Steel Group, Wuhan 430080

Received:2019-11-08 Published:2020-04-01 Online:2022-04-22

摘要/Abstract

摘要： 对07MnCrMoR水电钢板的淬透性曲线进行了测定,利用淬火机和热处理炉对100 mm厚试验钢板进行了淬火和回火试验,并对试验钢进行了组织观察和力学性能测定。结果表明,随着试验钢距水冷端的距离增大,淬火组织由马氏体转变为粒状贝氏体,距离端部50 mm处转变为铁素体和粒状贝氏体的混合组织。试验钢板利用淬火机淬火后得到板条贝氏体+粒状贝氏体+先共析铁素体,回火后转变为铁素体+粒状贝氏体,同时大量的碳化物在铁素体基体和晶界处析出。试验钢最合理的热处理工艺为930℃ 30min水冷淬火,660℃ 60min空冷回火。

Abstract: The curves of hardenability of 07MnCrMoR hydropower steel plate are tested, and the 100 mm thick tested steel plate is quenched and tempered by heat treatment furnace and quenching equipment, and the structure of and mechanical properties of test steel are observed and measured. The results show that with increasing the distance from cooling end the microstructure of tested steel transforms from martensite to granular bainite, and transforms to ferrite and granular bainite microstructure at 50 mm from the water-cooled end. The lath bainite + granular bainite + pre-eutectoid ferrite are obtained in test steel plate after quenching by queching equipment, then transforming into ferrite + granular bainite after tempered ,and a large number of carbides precipitating at ferrite matrix and grain boundary. The most reasonable heat treatment process of the test steel is water-cooled quenching at 930 ℃ for 30 min and air-cooled at 660℃ for 60 min.

Key words: Ultea-thick, 07MnCrMoR, Hydropower Steel, Quenched and Tempered, End Quenching Test

冯路路, 乔文玮, 鲁修宇. 热处理工艺对100mm特厚07MnCrMoVR水电钢板组织性能的影响[J]. 特殊钢, 2020, 41(2): 62-65.

Feng Lulu, Qiao Wenwei , Lu Xiuyu. Effect of Heat Treatment Process on Microstructure and Properties of 100 mm Ultra-thick 07MnCrMoVR Hydropower Steel Plate[J]. Special Steel, 2020, 41(2): 62-65.

参考文献

[1]肖桂枝，朱伏先,邸洪双等.610 MPa级大型石油储罐用高强度钢板的开发[J].钢铁研究学报,2008,20( 11) ：55-58.
[2]孙卫华，王国栋,陈启祥等.非调质型15万m3石油储备罐体用610MPa高强度钢板轧制和热处理工艺研究与实践[J] .钢铁研究学报,2010,22(18):50-54.
[3]李新玲，应传涛,丛津功等-610MPa级水电钢减量化生产工艺研究[J].鞍钢技术,2016,32(4)： 32-34.
[4]李新玲,乔馨，高强,石油储罐用钢12MnNiVR在线冷却工艺研究[J].钢铁研究学报,2011,23(增刊1) U52-158.
[5]石昆，侯洪,李金富等.调质态07MnNiMoDR钢脆性断裂机制及冲击功离散性[J].东北大学学报(自然科学版)，2017, 38(3):350-355.
[6]吴斌，金.茄,隋鹤龙等.水电站用高强度压力钢管用钢的研制开发[C].2009年全国高品质热轧板带材控轧控冷与在线、离线热处理生产技术交流研讨会文集，北京-2009,16th： 223¬228.
[7]刘智良，史兴隆，董瑞峰.非标准小试样端部淬透性试验方法 [J].热加工工艺,2019,48 (13)： 156-158.
[8]Chen J, Li C S and Chen L Q,et al. Controlling of Reheated Quenching Temperature of 1000MPa Grade Steel Plate for Hydropower Station [J]. Materialwiss,2019,50( 1) ：33-43.
[9]Xu Zhibao, Hui Weijun and Wang Zhanhua,et al. Mechanical Properties of a Microalloyed Bainitic Steel After Hot Forging and Tempering [J]. Journal of Iron and Steel Research, International ,2017,24 (11):1085-1094.
[10]卜凡征，王玉斌,郑连辉等.Ti-Mo微合金钢回火过程中纳米碳化物析出行为[J].钢铁研究学报,2018,30(11) ：928-934.
[11]石骁，吴建中,郭汉杰等.DH36高强度船板钢中碳化物及碳氮化物析出行为[J].中南大学学报(自然科学版),2018,49 (3):518-527.
[12]马耿魏，其其格.610 MPa级压力容器用钢回火工艺参数的研究[J].上海金属,2011,33(2):14-17.