Morphology and Distribution of Ferrite in 304 Stainless Steel 2.0 mm Strip Produced by Twin-roll Concasting
|更新时间:2026-01-21
|
Morphology and Distribution of Ferrite in 304 Stainless Steel 2.0 mm Strip Produced by Twin-roll Concasting
Special SteelVol. 29, Issue 3, Pages: 10-12(2008)
作者机构:
1. 北京科技大学冶金与生态工程学院,北京,100083
2. 宝钢研究院前沿技术研究所,上海,201900
作者简介:
基金信息:
DOI:
CLC:
Received:16 November 2007,
Online First:20 December 2022,
Published:20 December 2008
稿件说明:
移动端阅览
季晨曦, 王新华, 方园. Morphology and Distribution of Ferrite in 304 Stainless Steel 2.0 mm Strip Produced by Twin-roll Concasting[J]. Special Steel, 2008, 29(3): 10-12.
DOI:
季晨曦, 王新华, 方园. Morphology and Distribution of Ferrite in 304 Stainless Steel 2.0 mm Strip Produced by Twin-roll Concasting[J]. Special Steel, 2008, 29(3): 10-12.DOI:
Morphology and Distribution of Ferrite in 304 Stainless Steel 2.0 mm Strip Produced by Twin-roll Concasting
The morphology and distribution of retained ferrite in 304 austenite stainless steel(0.08C
1.37Mn
0.62Si
17.77Cr
9.09Ni)2.0 mm cast strip have been studied by chemical etching
colour metallurgraphy and electro- probe microanalyser(EPMA).Results showed that the ferrite in strip surface area presented rod-like morphology and the space between rod was ≤20 μm; in columnar dendrite area
the ferrite located at center of both primary and secondary dendrite arms and the space between ferrite secondary arms was ≤10 μm; in center of strip-equiaxed zone
the morpholo- gy and distribution of ferrite was related to semisolid formation mechanism of equiaxed grains.The ferrite in initially solidi- fied solid-phase particles presented curved dendrite and netlike morphology
while the ferrite in inter-space of initially solid- ified particles presented island morphology.