ISSN:1003-8620

CN:42-1243/TF

Governed by: CITIC Pacific Special Steel Group Co., LTD

Sponsored by: Daye Special Steel Co., LTD.

Special Steel ›› 2009, Vol. 30 ›› Issue (6): 34-35.

Previous Articles     Next Articles

Process Practice for Reducing Width of Side Reversal of Hot Rolled Coil by Reentrant Casting of Slab

Yin De   

  1. Taiyuan Iron and Steel (Group) Co Ltd, Taiyuan 030003
  • Received:2009-05-29 Online:2009-12-01 Published:2022-11-15

连铸板坯侧凹浇铸减少热轧钢卷侧翻宽度的工艺实践

尹德   

  1. 太原钢铁(集团)有限公司,太原030003
  • 作者简介:尹 德(1964-),男,高级工程师,1986年太原工业大学毕 业,钢铁生产管理。

Abstract: Effect of reentrant casting of slab on the side reversal ( both side roughness band) of hot rolled coil and the mold life is obtained by test of reentrant casting of 180 mm X 1 238 mm 0Cr18Ni9 stainless steel slab. Results show that as the cast slab side reentrant value is 3 ~4 mm, the average width of side reversal of coil decreases to 9. 3 mm from original 11.2 mm, it is available to increase the utilization rate of coil, while the damage of mold is minor.

Key words: Hot Rolled Coil, Side Reversal, Casting Slab, Reentrant Casting

摘要: 通过0Cr18Ni9不锈钢180 mm×1 238 mm连铸板坯侧凹浇铸试验,得出连铸板坯侧凹浇铸对热轧钢卷侧翻(两边粗糙带)和结晶器寿命的影响结果表明,当连铸板坯边部侧凹3~4 mm浇铸时,钢卷侧翻平均宽度由原先的11.2 mm降低至9.3 mm,提高了钢卷的利用率,同时对结晶器的损害很小。

关键词: 热轧钢卷, 侧翻, 连铸板坯, 侧凹浇铸