An Analysis on Effect of Al on Impact Toughness of Fe-Cr High Temperature Alloy by Empirical Electron Theory (EET)

Special Steel ›› 2012, Vol. 33 ›› Issue (4): 67-70.

An Analysis on Effect of Al on Impact Toughness of Fe-Cr High Temperature Alloy by Empirical Electron Theory (EET)

Gao Xueyun¹, Chen Shouliang², Wang Haiyan^2,3, Hou Jingli³ ， Ren Huiping³

1 Long Product Division, Zhongye East Engineering Technology Co Ltd, Baotou 014010.
2 School of Materials Science and Engineering, University of Science and Technology, Beijing 100083;
3 School of Materials and Metallurgy, Inner Mongolia University of Science and Technology, Baotou 014010

Received:2012-02-03 Online:2012-08-01 Published:2022-10-25

利用经验电子理论(EET)分析Al对Fe-Ci高温合金冲击韧性的影响

高雪云¹，陈守良²，王海燕^2,3，侯景利³，任慧平³

1中冶东方工程技术有限公司长材事业部，包头014010；
2北京科技大学材料科学与工程学院，北京100083；
3内蒙古科技大学材料与冶金工程学院，包头014010

作者简介:高雪云(1980-)，男，硕士，助理工程师,2011年北京科技大学毕业，稀土高温材料和轧制工艺研究。

Abstract

Abstract: The phase diagram of a new aluminum-bearing Fe-Cr alloy (/%: 1. 60C, 26. OOCr, 5. 50Al, 0. 50Ni,
0. 12Y) is calculated by using thermodynamics software Thermal calc and combined with X-ray diffraction analysis the phase composition of the new alloy is defined. On this basis, the valence electron structure, covalent bond energy and lattice electrons of conventional high chromium cast iron and aluminum-bearing Fe-Cr alloys are analyzed by using solid and molecule empirical electron theory (EET) to reveal the mechanism for impact toughness decreasing of aluminum-bearing Fe-Cr alloy at electronic level. Results show that with adding 5. 50% Al, the aluminum-bearing structure units occur in Fe- Cr alloy, the strongest bond covalent electron pairs in the units decrease from 0. 486 40 to 0. 450 31, second strong bond covalent electron pairs also decrease from 0. 199 83 to 0. 118 88, while the number of lattice electrons decreases led to the impact toughness lowing. The EET predicting results for impact toughness of Fe-Cr alloy containing 5. 50% Al nicely coincide with the test measured results.

Key words: , Aluminium, Fe-Cr Alloy, Impact Toughness, Empirical Electron Theory

摘要： 采用Thermal calc热力学软件,计算了新型含铝Fe-Cr合金(/%:1.60C、26.00Cr、5.50Al、0.50Ni、0.12Y)的相图,结合X射线衍射分析,确定了该合金的相组成。在此基础上,运用固体与分子经验电子理论(EET),分析了普通高铬铸铁和含铝Fe-Cr合金的价电子结构、共价键键能以及晶格电子数,从电子层面揭示含铝Fe-Cr合金冲击韧性下降的微观机理。结果表明,添加5.50%Al后,Fe-Cr合金中出现了含铝结构单元,这些单元中最强键共价电子对数从0.48640降低为0.450 31,次强键共价电子对数也从0.199 83降低到0.118 88,同时晶格电子数有所减少,从而导致其冲击韧性下降。含5.50%Al的Fe-Cr高温合金冲击韧性的EET预测结果与实测结果吻合良好。

关键词: 铝, Fe-Cr合金, 冲击韧性, 经验电子理论

Gao Xueyun , Chen Shouliang , Wang Haiyan, Hou Jingli , Ren Huiping. An Analysis on Effect of Al on Impact Toughness of Fe-Cr High Temperature Alloy by Empirical Electron Theory (EET)[J]. Special Steel, 2012, 33(4): 67-70.

高雪云, 陈守良, 王海燕, 侯景利, 任慧平. 利用经验电子理论(EET)分析Al对Fe-Ci高温合金冲击韧性的影响[J]. 特殊钢, 2012, 33(4): 67-70.

References

1 Nie X,Meletis E I,Jiang J C,et al. Abrasive Wear/Corrosion Properties and TEM Analysis of Al2 03 Coatings Fabricated using Plasma E- lectrolysis. Surface and Coatings Technology ,2002,149(2-3) ：245
2 Hemnann J, Inden G, Sauthoff G. Deformation Behavior of Iron-Rich Iron-Aluminum Alloys at High Temperatures. Acta Materiales, 2003, 51 :3233
3 Guo Eijun, Wang Liping, Huang Yongchang, et al. Effects of Rare Earths and Al on Structure and Performance of High Chromium Cast Iron Containing Wolfram. Journal of Rare Earths ,2006 ,24 ：238
4符寒光，洪桃生,胡玉平.多元合金高铬铸铁篦条的研制和应用.现代铸铁,2004(5) ：32
5孙志平，沈保罗，王均，等.利用EET理论预测Fe-C-Cr系高铬铸铁的淬硬性.四川大学学报(工程科学版),2004,36(6) ：71
6刘志林.合金价电子结构与成分设计.长春:吉林科学技术岀版社，1990
7师瑞霞，杨瑞成,尹衍生，等.合金元素对12CrlMoV钢中Fe的自扩散和C的扩散能力的影响.钢铁研究,2004(2) ：34
8张建民，张瑞林,郑伟涛，等.A1含量对Fe-Al无序固溶体性能的影响.材料科学与工艺,1995,3(3) ：20
9刘志林.合金电子结构参数统计值及合金力学性能计算.北京:冶金工业出版社,2008
10 Fu Baoqin,Liu Wei, Li Zhilin. Calculation of the Surface Energy of Fcc-metals With the Empirical Electron Surface Model. Applied Surface Science ,2010,256 ：6899
11 Gao Yingjun,Hou Xianhua,Mo Qifeng,et al. Atomic Bonding of Precipitate and Phase Transformation of Al-Cu-Mg Alloy. Jounal of Alloys and Compounds,2007 ,441 ：241
12 彭可，易茂中，冉丽萍.MoSi2 fn WSi2的价电子结构及性能分析.金属学报,2006,42(11):1125
13 范润华，尹衍升,毕见强，等.Fe-25A1铝化物的电子结构及其本质脆性.人工晶体学报,2002,31(5):468

[1]	Peng　Feng, Li　Xu, Li　Bopeng, Zhang　Yue, Wang　Zhanzhong, Guo　Shibei. Development of 10.9 Grade 32CrB4 Quenched and Tempered Round Steel for Fasteners [J]. Special Steel, 2024, 45(6): 8-11.
[2]	Zhao　Jiawei, Tian　Jialong, Yang　Ping, Zhan　Dongping, Jiang　Zhouhua. Effect of Dual-aging Process on Microstructure and Properties of Co-precipitation Hardening Ultra-high Strength Steel [J]. Special Steel, 2024, 45(6): 88-94.
[3]	Zhao　Bo, Wang　Shanbao, Xie　Degang, Yuan　Qin, Ai　Fangfang, Wang　Xixiang, Guo　Jinmei. Microstructure and Properties of Seamless Steel Pipe Gr.6 after Rolling and Normalizing [J]. Special Steel, 2024, 45(6): 102-107.
[4]	Tang Yuanshou, Zhang Shiqing, Li Fang, He Qinsheng, Zhao Zhen, Wang Hong, Zou Xingzheng, Wang Jianqiao, Huang Yali. Effect of Quenching Temperature on Mechanical Properties of M₆C Reinforced 2 200 MPa Ultra-high Strength Steel [J]. Special Steel, 2024, 45(5): 108-112.
[5]	Wang Shaobing, Sun Wenqiang, Wang Man, Zhou Zhu, Liu Zhengdong, Zhong Qiang. The Effect of Nb on Microstructure and Properties of GH4169 Alloy Pipe [J]. Special Steel, 2024, 45(5): 34-39.
[6]	Wang Shucai, Guo Jing, Wu Zhilong, Han Kui, Zhao Yue, Chen Xiuqiang. Low-cost Non-vacuum Induction Furnace Smelting of High Molybdenum Content of Nickel-base Alloy [J]. Special Steel, 2024, 45(5): 72-75.
[7]	Li Qing. Effect of Solid Solution Temperature on Microstructure and Tensile Properties of GH4163 Alloy [J]. Special Steel, 2024, 45(5): 97-101.
[8]	Yang Zhihao, Wang Linlin, Liang Tian, Jia Dongxiao, Ma Yingche, Wang Ping. Effect of Rare Earth Gd on Thermal Deformation Behavior of Ni-Cr-Mo Alloys [J]. Special Steel, 2024, 45(5): 8-18.
[9]	Li Yang, Zhao Guangdi, Zang Ximin, Jiang Haoyuan, Wang Zhaoyu. Effect of Boron on the Microstructure and Strength-Toughness of Fe-Cr-B-C Alloy after Heat Treatment [J]. Special Steel, 2024, 45(5): 25-33.
[10]	Qu　Xiaobo, Wang　Miao, Cao　Lei, Wang　Luyi, Rao　Zicai, Ji　Wenjie, Wu　Yanxin, Wu　Xiaoyan, Wang　Tianxiang, Jiang　Haitao. Effect of Microstructure Evolution on Mechanical Properties of 87Mnsi Steel Wire Rod for Bridge Cable [J]. Special Steel, 2024, 45(3): 114-118.
[11]	Zhang　Yudi, Liu　Jianhua, He　Yang, Li　Wei, Lin　Junyu, Chen　Xiujun, Bi Sheng. Industrial Experimental Study on Removal of Inclusions in Steel by Nitrogen Addition and Release Method [J]. Special Steel, 2023, 44(6): 53-57.
[12]	Xu　Letian, Liu　Liangyong, Li　Yunlong, Xu　Yaowen, Wan　Wuxia. Simulation Trial and Finite Element Simulation Study on Temperature Field of Pipes in Walking Beam Reheating Furnace [J]. Special Steel, 2023, 44(6): 89-95.
[13]	Wang　Weijian, Yang　Wen, Ren　Ying, Zhang　Lifeng. Development of the Guidance Software of Precise Calcium Treatment and Its Application in Special Steel Production [J]. Special Steel, 2023, 44(6): 25-30.
[14]	Liu　Chunwei, Zhang　Hao, Cao　Lei, Wang　Guocheng. Effect of VD Low Basicity Slag on Inclusions of GCr15 Bearing Steel [J]. Special Steel, 2023, 44(6): 78-82.
[15]	Liu　Qilong, Deng　Yong, Li　Huagang, Wei　Rujun, Cao　Chenghu, Zhang　Min. Numerical simulation and Process Practice of Mold Electromagnetic Stirring for IF Steel Slab [J]. Special Steel, 2023, 44(6): 83-88.