Precipitate Behavior of Second Phase and Structure of Annealed
1.5 mm Cold Rolling Sheet of Nb-Ti Microalloy
High Strength Steel

Special Steel ›› 2006, Vol. 27 ›› Issue (3): 26-28.

Previous Articles Next Articles

Precipitate Behavior of Second Phase and Structure of Annealed 1.5 mm Cold Rolling Sheet of Nb-Ti Microalloy High Strength Steel

Liu Hao^1,2,Chen Xiao^1,2,Li Pinghe²,Zheng Hong²,Wu Qingsong²，Liu Qingyou³

1 Material and Metallurgy Institute,Wuhan Science and Technology,Wuhan 430081;
2 Technical Center,Wuhan Iron and Steel Group Cooperation,Wuhan 430080;
3 Central Iron and Steel Research Institute,Beijing 100081

Received:2006-01-04 Online:2006-05-08 Published:2023-03-10

Nb-Ti微合金高强度钢1.5mm冷轧板退火组织和第二相析出行为

刘浩^1,2，陈晓^1,2，李平和²，郑红²，吴青松²，刘清友³

1武汉科技大学材料与冶金学院，武汉430081;
2武汉钢铁公司技术中心，武汉430080;
3钢铁研究总院，北京100081

作者简介:刘浩(1966-),男，高级工程师。1988年毕业于华南理工大学，在读博士生。从事汽车用微合金冷轧高强度钢的研究与开发。

Abstract

Abstract: The precipitate behavior of second phase and structure of 0.08C- 1.0Mn-Nb+Ti<0.10 microalloy high strength steel 1.5 mm sheet deformed by 53% annealed at 650 ℃ and 680 ℃ has been tested and studied by transmission electron microscope. the results showed that the second phase in test steel was(Ti,Nb)(C,N)compound precipitate phase, generally the size of second phase particles was 20~30 nm,and with increasing annealing temperature the amount of second phase increased. The higher strength(yield strength ≥480MPa at 650 ℃)is due to second phase precipitate strength and inhabiting gain growth to form fine grain.

Key words: , Cold Rolling,Nb-Ti Microalloying,High Strength Steel,Second Phase Precipitate,Stucture

摘要： 用透射电镜实验研究了(%):0.08C-1.0Mn-Nb+Ti<0.10微合金高强度钢经53%冷变形1.5 mm板650℃和680℃退火的组织和第二相析出行为。结果表明,试验钢中的第二相为(Ti,Nb)(C,N)复合析出相,第二相粒子尺寸一般为20~30 nm,随退火温度提高,第二相粒子的数量增加。由于退火过程第二相析出强化和第二相粒子抑制晶粒长大,使钢中晶粒细小,该钢650℃退火组织具有较高强度(屈服强度≥480 MPa)。

关键词: 冷轧, Nb-Ti微合金化, 高强度钢, 第二相析出, 组织

Liu Hao, Chen Xiao, Li Pinghe, Zheng Hong, Wu Qingsong, Liu Qingyou. Precipitate Behavior of Second Phase and Structure of Annealed 1.5 mm Cold Rolling Sheet of Nb-Ti Microalloy High Strength Steel[J]. Special Steel, 2006, 27(3): 26-28.

刘浩, 陈晓, 李平和, 郑红, 吴青松, 刘清友. Nb-Ti微合金高强度钢1.5mm冷轧板退火组织和第二相析出行为[J]. 特殊钢, 2006, 27(3): 26-28.

[1]	Peng　Feng, Li　Xu, Li　Bopeng, Zhang　Yue, Wang　Zhanzhong, Guo　Shibei. Development of 10.9 Grade 32CrB4 Quenched and Tempered Round Steel for Fasteners [J]. Special Steel, 2024, 45(6): 8-11.
[2]	Zhao　Jiawei, Tian　Jialong, Yang　Ping, Zhan　Dongping, Jiang　Zhouhua. Effect of Dual-aging Process on Microstructure and Properties of Co-precipitation Hardening Ultra-high Strength Steel [J]. Special Steel, 2024, 45(6): 88-94.
[3]	Zhao　Bo, Wang　Shanbao, Xie　Degang, Yuan　Qin, Ai　Fangfang, Wang　Xixiang, Guo　Jinmei. Microstructure and Properties of Seamless Steel Pipe Gr.6 after Rolling and Normalizing [J]. Special Steel, 2024, 45(6): 102-107.
[4]	Tang Yuanshou, Zhang Shiqing, Li Fang, He Qinsheng, Zhao Zhen, Wang Hong, Zou Xingzheng, Wang Jianqiao, Huang Yali. Effect of Quenching Temperature on Mechanical Properties of M₆C Reinforced 2 200 MPa Ultra-high Strength Steel [J]. Special Steel, 2024, 45(5): 108-112.
[5]	Wang Shaobing, Sun Wenqiang, Wang Man, Zhou Zhu, Liu Zhengdong, Zhong Qiang. The Effect of Nb on Microstructure and Properties of GH4169 Alloy Pipe [J]. Special Steel, 2024, 45(5): 34-39.
[6]	Wang Shucai, Guo Jing, Wu Zhilong, Han Kui, Zhao Yue, Chen Xiuqiang. Low-cost Non-vacuum Induction Furnace Smelting of High Molybdenum Content of Nickel-base Alloy [J]. Special Steel, 2024, 45(5): 72-75.
[7]	Li Qing. Effect of Solid Solution Temperature on Microstructure and Tensile Properties of GH4163 Alloy [J]. Special Steel, 2024, 45(5): 97-101.
[8]	Yang Zhihao, Wang Linlin, Liang Tian, Jia Dongxiao, Ma Yingche, Wang Ping. Effect of Rare Earth Gd on Thermal Deformation Behavior of Ni-Cr-Mo Alloys [J]. Special Steel, 2024, 45(5): 8-18.
[9]	Li Yang, Zhao Guangdi, Zang Ximin, Jiang Haoyuan, Wang Zhaoyu. Effect of Boron on the Microstructure and Strength-Toughness of Fe-Cr-B-C Alloy after Heat Treatment [J]. Special Steel, 2024, 45(5): 25-33.
[10]	Qu　Xiaobo, Wang　Miao, Cao　Lei, Wang　Luyi, Rao　Zicai, Ji　Wenjie, Wu　Yanxin, Wu　Xiaoyan, Wang　Tianxiang, Jiang　Haitao. Effect of Microstructure Evolution on Mechanical Properties of 87Mnsi Steel Wire Rod for Bridge Cable [J]. Special Steel, 2024, 45(3): 114-118.
[11]	Zhang　Yudi, Liu　Jianhua, He　Yang, Li　Wei, Lin　Junyu, Chen　Xiujun, Bi Sheng. Industrial Experimental Study on Removal of Inclusions in Steel by Nitrogen Addition and Release Method [J]. Special Steel, 2023, 44(6): 53-57.
[12]	Xu　Letian, Liu　Liangyong, Li　Yunlong, Xu　Yaowen, Wan　Wuxia. Simulation Trial and Finite Element Simulation Study on Temperature Field of Pipes in Walking Beam Reheating Furnace [J]. Special Steel, 2023, 44(6): 89-95.
[13]	Wang　Weijian, Yang　Wen, Ren　Ying, Zhang　Lifeng. Development of the Guidance Software of Precise Calcium Treatment and Its Application in Special Steel Production [J]. Special Steel, 2023, 44(6): 25-30.
[14]	Liu　Chunwei, Zhang　Hao, Cao　Lei, Wang　Guocheng. Effect of VD Low Basicity Slag on Inclusions of GCr15 Bearing Steel [J]. Special Steel, 2023, 44(6): 78-82.
[15]	Liu　Qilong, Deng　Yong, Li　Huagang, Wei　Rujun, Cao　Chenghu, Zhang　Min. Numerical simulation and Process Practice of Mold Electromagnetic Stirring for IF Steel Slab [J]. Special Steel, 2023, 44(6): 83-88.

Precipitate Behavior of Second Phase and Structure of Annealed 1.5 mm Cold Rolling Sheet of Nb-Ti Microalloy High Strength Steel

Nb-Ti微合金高强度钢1.5mm冷轧板退火组织和第二相析出行为

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments